Pioneer VSX-47TX manual Dual Mono setting and playback, Input Attenuator, Tape 2 Monitor

Basic Operation

DUAL MONO setting and playback

The dual mono setting can only be used when listening to Dolby Digital or homemade discs that have dual mono software encoded in them. Dual mono software usually is used to put two different mono recordings with one soundtrack on one DVD. With this setting you can choose which channel in the dual mono setting you want to listen to. Remember this setting is only applicable if you are using Dolby Digital software with dual mono and want to isolate one of the channels therein.

							1	Press the LISTENING CH SELECT
ACOUSTIC	TONE		MULTI CH		TUNER	LISTENING MULTI ROOM & SOURCE		button for more than five seconds to
PHONES	SP SYSTEM SIGNAL VIDEO	TAPE2			STATION	CH SELECT CONTROL ON/OFF
CAL.	MIDNIGHT TONE BASS/TEREBLE		DIGITAL NR CLASS
	A/B SELECT SELECT	MONITOR INPUT						put the receiver in DUAL MONO
			(DVD-A/SACD)		S-VIDEOVIDEO INPUT		L AUDIO R
			SETUP	DIGITAL IN
			MIC			VIDEO
								mode.
								Hold down the LISTENING CH SELECT button to cycle
								through the different DUAL MONO settings. When you
					1			find the one you want release the button. The L (ch1)
								and R (ch2) indicators in the display light to indicate the
								playback channel.

•The default setting is DUAL ch1. memo • You can only use this function with

Dolby Digital sources that have this function

DUAL : ch1 DUAL : ch2

DUAL: ch1/ch2

The different settings are: DUAL ch1, where you only hear channel 1; DUAL ch2, where you only hear channel 2; and DUAL ch1/ch2, where you hear both channels, but independently from different speakers.

Input Attenuator

The input attenuator lowers the input level of an analog signal when it is too strong, causing distortion in the sound.

SETUP

S0URCE	TV	SYSTEM RECEIVER
		OFF
DVD/LD	TV	SAT	TV CONT
MULTI CONTROL
VCR1/	VCR2	VIDEO	MULTI
DVR			OPERATION

1Press RECEIVER.

2Use the INPUT ATT button on the remote control.

2	CD	CD-R/
		TAPE1
	DIMMER	INPUT ATT
	1	2
	VIDEO SEL	SIGNAL SEL
	5	6
	TONE	BASS/TREBLE

9 0

TUNER	RECEIVER	1
LOUDNESS	SPEAKER A/B

3 4

TAPE 2 EFFECT/CH SELL

7 8

–+10 + DISC

ENTER

D RECT ACCESS D SP MODE

Tape 2 Monitor

If you connect a cassette deck with a record monitor function (a three-head tape deck) to the TAPE 2 MONITOR jacks, you can listen to the sound of an analog recording as it’s being recorded.

1 Press RECEIVER.

SETUP

S0URCE	TV	SYSTEM RECEIVER
		OFF
DVD/LD	TV	SAT	TV CONT
MULTI CONTROL
VCR1/	VCR2	VIDEO	MULTI
DVR			OPERATION

CD	CD-R/	TUNER	RECEIVER
	TAPE1
DIMMER	INPUT ATT	LOUDNESS	SPEAKER A/B

1 2 3 4

	VIDEO SEL	SIGNAL SEL	TAPE 2	EFFECT/CH SELL
54	5	6	7	8
	TONE	BASS/TREBLE	– +10 + DISC
	9	0		ENTER
	SYSTEM SETUP		DIRECT ACCESS DISP MODE
				REMOTE SETUP

1

2

2Use the TAPE 2 MONITOR button on the remote control to listen to the component hooked up to the TAPE 2 MONITOR jacks.