Pioneer VSX-47TX manual Press ENTER. The preset code has Been entered

Remote Control of Other Components

	VIDEO SEL	SIGNAL SEL	TAPE 2	EFFECT/CH SELL
	5	6	7	8
	TONE	BASS/TREBLE	– +10 + DISC
	9	0		ENTER
		DIRECT ACCESS DISP MODE
6-9	SYSTEM SETUP			REMOTE SETUP
	MENU
	TUNER EDIT
		ENTER
	STATUS			EXIT
	GUIDE			RETURN
	MPX	DTV ON/OFF
	¶	8		EXTRA MENU
	TUNING –	BAND		TUNING +
	1	3		¡
	STATION –	DTV MENU CLASS		STATION +
	4	7		¢
	CHANNEL–			CHANNEL+

6Point the remote control at the component you want set and press

ENTER.

OK? will appear in the remote control display.

If the component you are trying to control turns on/off you have set it correctly. Use the 5∞ buttons to select YES and go on to step 7.

If the component you are trying to control does not turn on/off the correct preset code has not been selected. In this case, use the 5∞ buttons to select NO, press ENTER and go back to step 5. Try another preset code for that maker. (If the component you are trying to setup doesn't have a standby/on mode it won't turn on even if the correct preset code is entered. In this case select YES and go on to step 7.)

If you can't seem to get the component you are trying to set to turn on or off you can still set up your remote control by using the LEARNING mode (on the next page).

7Press ENTER. The preset code has

been entered.

COMPLETE will appear in the display.

Naturally it's easiest and most logical to assign the button that has the same name as the component you are setting up (for example, choose the DVD/LD button for your DVD player).

	You may find you have components which do not
	correspond to the name on any MULTI CONTROL
	button (for example a cable TV tuner) or you have two
	components where only one button is provided (for
	example, CD-R/TAPE 1). In this case, use step 3 to
	assign any available MULTI CONTROL button to the
	component you want to remote control.
	For example, you may have both a CD-R and a tape
	deck in your system but only one video deck. It would
	make sense to assign the CD-R/TAPE 1 MULTI
	CONTROL button to the CD-R and the VCR 2 MULTI
	CONTROL button to your tape deck. To do this choose
	VCR 2 in step 3 when you want to set up the tape
	deck. Then choose TAPE in step 4 and proceed as
	above. The only practical difference in this method is
	that you have to remember the VCR 2 MULTI CON-		OPERATION
	TROL button is actually your tape deck.
	In this case, you would need to hook up your tape
	deck to the input jacks marked VCR 2 on the back of
	the receiver.
	This method should help you customize the remote
	control for your system and let you control all of your
	components with the remote control for the VSX-47TX.
8	Repeat the process from step 2 for
	all of your components.
9	Select EXIT and press ENTER.	63