AVALON RF, INC. | Page 4 |
MX416 User’s Guide & Operating Manual |
|
2.Specifications
2.1User Interface - On/Off Switch.
The MX416 has an on/off switch. This shuts off power to the entire transmitter/ receiver.
2.2Setup.
Since the MX416 works as a pair, it is shipped with a sticker indicating the operating frequency e.g- 650 MHz. If you have ordered multiple sets, please ensure the correct pair is used. The user has to connect the antennas, power & audio cables & the link is ready to work. There is no specific setup procedure.
2.3Electrical Interface.
The transmitter has the following interfaces:
2.3.1Charger Input
a)The charger input is actually a battery charger connection. The external wall mount battery charger is connected to this jack.
b)This input is switched and protected against reverse polarity.
c)Charging is performed in the power “off” position.
2.3.2Microphone
a)The MX416 uses an electret microphone and is built into the case.
b)For volume orders, provision for connection of an external microphone can be made.
2.3.3RF output to antenna.
a) The RF output connector is a 50 Ω (ohm) MCX receptacle.
b)The RF output power is approx. 250 mW (transmit).