Telex FMR-500 specification

Trouble Shooting Guide (continued)

Problem	Possible Causes		Solutions

Interference (continued)	Receiver is too close to digi-		Move the receiver to a
	tal signal processor or similar		different location
	device
	Strong electromagnetic field		Use ClearScan to change the
	from stage lighting or other		operating frequency. Repair
	source near the transmitter or		or remove the source of in-
	receiver, which may be pro-		terference. Move the receiver
	ducing RF noise at or near		to a different location
	the operating frequency

Short range or drop-outs	RF reflective metal obstacles		Move the obstacles, or repo-
	between	the transmitter and	sition the receiver/antennas
	receiver

	Poorly	oriented beltpack	Check the antenna connec-
	antenna		t i o n a n d re - o ri e n t t h e
			bodypack so the antenna is
			vertical (up and down) and
			facing the receiver, if possi-
			ble

	Faulty receiving antenna		Check all antenna connec-
	system		tions and reposition to be in
			line-of-sight with the trans-
			mitter

Can't change settings on	Lock-out feature is enabled		Disable lock out
receiver or transmitter			(see pages 3 and 9)

B o d y p ac k o r H an d h e l d	On/Off lock-out is engaged		Put the on/off switch in the
transmitter will not turn off,			off position and press one of
display says On-Loc			the programming buttons
			(see page 9)

-11-