Korg ES-1 manual Deleting event data from a song, Checking for song event data

Page 51

6. Song mode

Recording performances or knob

movements into a song

(Event Recording)

In addition to putting patterns together to create a song, Song mode also allows you to realtime-record knob movements and your performances on the part keys.

Recording this data in Song mode is referred to as "event re- cording."

Four types of musical data (event data) can be recorded by event recording.

·Pressing the part keys

·Using Part Mute or Part Solo

·Movements of the knobs or switches (only for the selected part)

·Tempo

Event recording allows you to record two or more types of events in the same area, as long as the events are played at the same time.

Event recording always rewrites the previous data ("replace recording"), and when you record your performance, any event recording data previously in that area will be erased. (It is not possible to layer event recording over the same area.)

1.Select the song on which you wish to record events.

2.Use the cursor keys to make the parameter select LEDs indi- cate Position.

3.Use the dial or the Select keys to move to the position at which you wish to begin recording.

4.Press the Rec key, and then press the Play/Pause key to be- gin event recording.

5.Use the part keys and/or the knobs to perform.

6.Press the Stop/Cancel key to stop event recording.

Deleting event data from a song

To delete event data from a song, you can perform event re- cording over the area that you wish to delete (without operat- ing any knobs or keys).

Checking for song event data

If event data has been recorded in a song, holding down the Shift key and pressing the Motion Sequence key will make step keys 13 through 16 light.

It is not possible to check for event data during playback or recording.

1,3

5

2

 

 

 

4

4

5

5

 

 

Knob movements that are event-recorded in Song mode will always playback in a way that corresponds to the Smooth type motion sequence setting (and not the Trig Hold type).

If you wish to save the event recording, you must perform the Write operation. If you switch songs or turn off the power without performing the Write operation, the re- corded performance will be lost.

If during playback you operate a knob that had been event- recorded, playback of the events of that knob will be can- celled until it reaches the next position. However if you modify the tempo that was event-recorded, the tempo will be cancelled until the end of the song.

After rewinding a song, it may not be possible to play- back exactly according to the event data.

6. Song mode

51

Image 51
Contents Page CE mark for European Harmonized Standards FCC Regulation Warning for U.S.AContents Directly sampling the sound of the ES-1 Resampling Pattern modeSong mode Global modeAppendices Main features IntroductionData you create on the ES-1 Preparing to play Adapter cable holder Power switch AC Local VoltageMake connections and play Example connectionsConnector section Front and rear panelCommon section Effect section Part Edit sectionFront and rear panel Sequence Control section Part Select sectionSelect key Step Key sectionPower switch Connector sectionListening to a Song Conceptual diagram of the ES-1What is a Song? Basic operation Quick StartListening to a Sample What is a Pattern?What is a Sample? Listening to a PatternChanging the tempo of a song or pattern Using the dial to change the tempoUsing the Tap Tempo key to change the tempo Trying out the functionsStriking the part keys along with a song or pattern Editing the effect and delay settingsWhat is the Part Edit section? Modifying editing the soundBasic operation Quick Start Modifying editing a rhythm pattern Using the step keys to edit the rhythm Step RecordingWhat is a Rhythm Pattern? What is Length?Erase Using the part keys to edit the rhythm Realtime RecordingSaving a pattern you create Write What is a Motion Sequence? Using a Motion SequenceSound heard from Audio In line output Connecting various sources to the audio inputsInput from CD or MD, etc Peak LED Sound input from AudioInput from CD or MD, etc Let’s record a sampleSample sound Assigning a sample sound to a sample partAbout the Slice function About the Resample functionMidi keyboard etc Using the ES-1 as a tone generator moduleWhat is Pattern Set? Playing with Pattern SetSynchronizing with an EA-1 or ER-1 Recording a sample Sample modeSelecting a sample Playing a sampleDirectly sampling the sound ES-1 Resampling Specifying the start locationSpecifying the end location Specifying the fade-out LengthResampling just one note of a part Resampling from the middle of a Pattern or songSlice Creating a slice sample Time SliceScale/Beat Normalize End Start Before Truncate After Truncate Sample modeOther functions for editing Sample Tips for achieving good results With Time SliceChecking the remaining Amount of sampling area Memory Once a sample has been deleted, it cannot be recoveredDeleting a sample Delete Sample Saving a sample WritePattern Play Pattern modeSetting the playback tempo Playing a patternPart Solo function Display when no parts are soloed Solo one partSelecting parts Part Mute functionAssigning a sample Creating a patternEditing effect and delay Decimator Ring Mod. ring modulationPitch Shifter CompressorBPM Sync Length, Scale/Beat settingsTime delay time Msec .. sec For BPM Sync 1/4...8 Motion Seq motion sequencePattern mode Swing settingsSetting the Length Setting the Scale/Beat 16, 32, tri, tr2Creating a Rhythm Pattern Setting the Roll TypeUsing the step keys Step Recording Using the part keys Realtime RecordingPlaying an effect motion sequence Motion sequencePlaying a motion sequence Recording a motion sequenceChecking motion data Playing a delay motion sequenceRecording a delay motion Sequence There will be no effect if the delay Motion Seq is off darkErasing data during playback or recording Erase Convenient functions for Editing patternsErasing rhythm pattern data from Copying a part Copy Part PartCopy Pattern data Data Copy within a patternEditing motion sequence Data Selecting a motion sequenceEditing the parameter values of a Motion sequence Pattern set Using Pattern Set to perform Pattern Set PlayPattern Set Registering a pattern for Pattern SetSaving a pattern Write Song mode Selecting a songPlaying a song Song Play Erasing song data Clear Song Song modeCreating a song Creating a song from scratchChanging the pattern for a specific position Editing a songInserting a pattern at a specified posi Tion Insert Pattern Deleting a pattern from a specified Position Delete PatternChecking for song event data Deleting event data from a songSaving a song Write Metronome OFF, r-0, r-1, r-2, on Global modeMetronome settings Global modeSetting the Midi note num Ber for each part Note No Audio In Mode Monaural, St. stereoMidi ch Saving data to SmartMedia Save Using SmartMediaTMFormatting Smart Media Format Loading all data from SmartMedia To the ES-1 All LoadLoading only a single sample From SmartMedia Sample Load Saving your changes Global mode WriteWith the factory settings, this is turned on Memory Protect ProtectAbout Midi AppendicesTroubleshooting Transmitting sound settings Other data Data DumpEditing sounds etc Specifications Error messagesIndex Pattern Set Play TroubleshootingPattern Play Rhythm Set 11, 25 WriteBank Pattern Name ListSample Name List Song Name ListTransmitted Recognized Remarks Function Midi Implementation ChartSampler 2000.5.15Korg INC