Seagate ST118202LW/LC manual Drive models, General information

Page 21

Cheetah 18 Installation Guide, Rev. A

19

Initial setup information

The general information beginning on this page applies to all of the Cheetah 18 drive models. After reading the general informa- tion topics, refer to the appropriate drive-specific section listed below for additional information about configuring and installing your particular model.

Drive models	Page
ST118202LW	39
ST118202LC	45

General information

The following general information topics are discussed:

•Single-ended and low voltage differential modes

•SCSI ID jumpers

•Drive termination

•Terminator power

•Interface drivers and data path width notes

•Other applicable jumper options

•Providing adequate cooling

•Mounting the drive and connecting cables1

•Formatting the drive

1This mounting procedure does not apply to “LC” model drives. To mount an “LC” drive, plug the drive into the system’s single connector attachment (SCA) position on the system’s back panel.

Image 21

Contents Cheetah Disc Drive ST118202LW/LC Installation Guide Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Cheetah 18 Installation Guide, Rev. a Electromagnetic susceptibility Regulatory agency complianceElectromagnetic compliance for the European Union Seagate Technology support services SeaNET Seagate CompuServe forum Online servicesSeaFAX FAX servicesTechnical support Direct-support servicesCustomer service centers Manufacturer’s representatives General description Cheetah 18 family drive ST118202LW shown Characteristics ST118202LW/LC DC power requirements ±5%1 +5 +12 General information Drive modelsScsi ID jumpers Single-ended and low voltage differential modesPage Drive termination Circuits and data path widths Terminator powerCable characteristics for SE and LVD circuits Pin I/O connection to drive LW model Multiple-drive connection to host adapter Drive model LC with single 80-pin I/O and power connector Providing adequate cooling Kühlung des Systems Suggested air flow Installation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesCheetah 18 Installation Guide, Rev. a DC power connector Abbildung 8. Gleichstromanschluß Hinweis Page Mounting configuration dimensions LW model Mounting configuration dimensions LC model Quick reference desktop system notes Formatting the driveLW drives Setting the Scsi ID jumpersTerminating the drive Setting terminator power jumpers Several other jumper options are available as illustrated Other applicable jumper optionsAdditional jumper options Drive Active LED indicator connections are shown below Drive Active indicatorLC drives Terminating the drive Other option jumpers are available as illustrated below Drive Active indicator