Seagate ST118202LW/LC manual Mounting the drive and connecting cables

Page 33

Cheetah 18 Installation Guide, Rev. A

31

Mounting the drive and connecting cables

Do not touch the connector pins or any components on the con- trol board without observing static-discharge precautions. Always handle the drive by the frame only.

The drive may be mounted in any orientation (horizontally, verti- cally, and any combination thereof); however, you must ensure that the drive receives adequate air flow for cooling.

1.Mount the drive to the host system’s chassis using four 6-32 UNC screws. Two mounting holes are in each side of the drive and there are four mounting holes in the bottom of the drive.

The maximum length that the screws should extend into the chassis mounting holes is 0.15 inch (3.81 mm), measured from the outer surface of the chassis. Tighten the screws down evenly. Do not over-tighten or force the screw if it does not seem to screw in easily, because this means the threads are not properly aligned. In this case, back the screw out and try again.

Installation des Laufwerkes und Anschluß der Kabel

Beachten Sie beim Handhaben und Anfassen der Anschlußstifte und Komponenten die Vorsichtsmaßnahmen zur Verhinderung statischer Aufladung. Fassen Sie das Laufwerk nur am Rahmen an.

Das Laufwerk kann in beliebiger Orientierung (horizontal, ver- tikal oder schräg) installiert werden; jedoch muß dafür gesorgt werden, daß ein ausreichender Luftstrom zur Kühlung des Lauf- werkes vorhanden ist.

Image 33

Contents Cheetah Disc Drive ST118202LW/LC Installation Guide Contents Electrostatic discharge protection PrefaceImportant safety information and precautions Page Wichtige Sicherheitshinweise Page Cheetah 18 Installation Guide, Rev. a Electromagnetic susceptibility Regulatory agency complianceElectromagnetic compliance for the European Union Seagate Technology support services SeaNET Seagate CompuServe forum Online servicesSeaFAX FAX servicesTechnical support Direct-support servicesCustomer service centers Manufacturer’s representatives General description Cheetah 18 family drive ST118202LW shown Characteristics ST118202LW/LC DC power requirements ±5%1 +5 +12 General information Drive modelsScsi ID jumpers Single-ended and low voltage differential modesPage Drive termination Circuits and data path widths Terminator powerCable characteristics for SE and LVD circuits Pin I/O connection to drive LW model Multiple-drive connection to host adapter Drive model LC with single 80-pin I/O and power connector Providing adequate cooling Kühlung des Systems Suggested air flow Installation des Laufwerkes und Anschluß der Kabel Mounting the drive and connecting cablesCheetah 18 Installation Guide, Rev. a DC power connector Abbildung 8. Gleichstromanschluß Hinweis Page Mounting configuration dimensions LW model Mounting configuration dimensions LC model Quick reference desktop system notes Formatting the driveLW drives Setting the Scsi ID jumpersTerminating the drive Setting terminator power jumpers Several other jumper options are available as illustrated Other applicable jumper optionsAdditional jumper options Drive Active LED indicator connections are shown below Drive Active indicatorLC drives Terminating the drive Other option jumpers are available as illustrated below Drive Active indicator