Peavey pRP 7 owner manual LED of the Transpose b button remains on to indicate

Page 17

Transpose

Pressing either TRANSPOSE button will adjust the pitch of the instru- ment in half-step (semitone) increments or decrements, through the overall range of –/+ 12 semitones.

When both LEDs are off, the pitch of the instrument is set to normal (Equal: C = C).

1.Press the TRANSPOSE # button once to raise the pitch of the instrument.

Play on the keyboard and you will hear that the pitch of the instrument is raised one semitone. The LCD display shows the current setting as a relative value, “01”, for a short period before returning to the tempo setting.

The LED of the TRANSPOSE # button remains on to indicate the

changed status of the pitch. Every time you press the TRANS- POSE # button, the pitch is raised by one semitone.

2.Press the TRANSPOSE b button to lower the pitch of the instrument.

Play on the keyboard and you will hear that the pitch of the instrument is lowered one semitone. The LCD display shows the current setting as a relative value, “–01” in this case, for a short period. A negative transposition value indicates that the pitch is one semitone lower than normal (00).

The LED of the TRANSPOSE b button remains on to indicate the

changed status of the pitch. Every time you press the TRANS- POSE b button, the pitch is lowered by one semitone.

After about 5 seconds, if you fail to press either Transpose button, the display returns to the previous situation and the instrument remains at the last set pitch.

The current Transpose setting remains memorized even after turning the instrument off. When you turn the instrument on again, the LED of the Transpose buttons will indicate the changed status of the pitch.

Reset

The current pitch setting can be cancelled instantly by pressing both buttons together.

i#

i #

i #

13

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Page General safety instructions Contents Appendix Introduction Front Panel Front and rear panelTouch Pedals Rear panelPlaying the pRP7 Pedal Connection Play using the Pitch/Modulation JoystickSelect a single demonstration song Listen to the Demo songsSelection buttons PRP7 PresetsPreset selection Change the Split point setting Activate Split modeControl section Realtime operationsAdd effects to the selected Preset Activate Layer modeChange the Volume Balance between two sounds LED of the Transpose b button remains on to indicate TransposeTouch Functions of the pRP7 Tune To raise the tuningMidi Channel Midi Local Midi Common channel Midi channels About MidiMidi messages transmitted and received by pRP7 As a Midi controlling device Midi ApplicationsAs a Slave device Midi Sequencer recordingRecording a song Recording StudioClick metronome Recording a new songSelect a sequence from the Song Library Song LibraryPanel Reset Damper Physical Model Technical specifications pRP7Technology Index Appendix Page PRP7 Midi Sound table GM-GMX PRP7 Presets PRP7 Song Library Drumkit Tables Drumkit tables A6 Appendix Midi Implementation Chart Control Change on tracks Federal Communications Commission Generalmusic Code
Top Page Image Contents