Peavey X-Four owner manual Rear panel features

Page 23

mono input module 1

rear panel features

direct out 1/4"TRS jack

The input channel's signal is available at this output jack.The default signal routing is derived post-fader, post-eq and post-mute.This output jack is ground-compensated.

insert points

Separate 1/4" TRS jacks provide the facilities for inserting an external sig- nal processor into the signal path of the input channel.

insert send

This jack serves as an output for connection to the input of a signal processor. The signal is derived after the mic preamp and HPF but before the eq section.Plugging a 1/4"TRS plug into this jack does not break the signal flow of the channel.This output jack is ground-compensated.

insert return

The output of a signal processor is fed to this jack.It can accept a balanced or unbalanced signal and is located pre-eq.

The insert send can	+
also be used as an

additional channel output when s pre-EQ signal is needed.

balanced line-in jack—Bal Line In

Line-level signals, balanced or unbalanced, may be brought into the input channel through this jack.The LINE switch must be depressed for this jack to be active.

In situations where	+
the preamp circuitry is	+
not needed, the Insert

Return can be used as the channel’s input.

For example, when using an expensive tube mic preamp.

balanced mic-in xlr connector—Bal Mic In

FThis balanced female XLR accepts a low-impedance microphone signal, or a line-level signal, depending on position of the LINE switch on the front panel.

see—mono input module, phantom power, line

p. 23

Image 23

Contents Four mixing console Manual Table of contents Page Conventions Module Block diagram Panel Line FeaturesPhantom power-+48V PadMono input module High-pass filter-HPF GainModule EQ features 1mono input module Aux stereo 5/6 Aux send featuresAux sends Aux 1-4, 5/6 pre-fader-PREPanel Mute Bus assignment featuresLeft-center-right-LCR Pan controlMono input module Mono input module Mono input module Signal present indicator-SIG Level meter featuresPeak indicator-PK Signal level LED’sMono input module Pre-fader listen-PFL Mono assignment-MLeft / right assignment-L-R Group 1-4 assignment1mono input module Rear panel features Stereo input module Line select-Line Left and right mono-switchesStereo input module Input gain-GAIN Stereo input module Equalizer-EQ on Four-band stereo EQ featuresPanel Stereo balance 5 and 6-STEREO Aux send 1-6 controls2stereo input module Balance control 2stereo input module Left/right assignment-L/R 2stereo input module Balance on-groups-BAL on 2stereo input module Line-input left and right 1/4TRS jacks Balanced left and right line-in XLR connectorsLine-input left and right RCA connectors Group module Mid frequency-MID Output eq featuresGroup module Group equalization -per output channel-EQ to Group Group module Post-group Matrix featuresMatrix 1-2 levels-M1, M2 Panel After-fader listen-AFL Fader reverseReversing aux / group and aux / main Aux 1-6 output levelGroup module Pan Group assignment featuresMono assignment-fromgroup-MONO Left/right assignment-fromgroup-L/RGroup module Fader Group/aux level featuresSignal/peak LED’s Panel Group insert return Group outputGroup insert point Group insert sendLamp dim switch and DC in connector Group inputs Auxiliary 1-6 output XLR’sAux insert point Aux insert sendModule Block diagram High frequency-HF Master module Left,right,mono equalization-EQ to LEFT,TO RIGHT,TO Mono Module External input levels-MATRIX1-2 Left, right, and mono levels-MATRIX1-2Post-left, post-right, post-mono Panel Matrix 1-2 talkback-TALK to Matrix output featuresMaster output levels-MTX1-2 Master module Sum mono Alternate out featuresPre switch Alternate out levelMaster module Headphone level Monitor output featuresMonitor-out level Solo-offFour Block Diagram Sum left/right-SUM L/R Left master featuresSignal/peak LED-SIG/PEAK Talkback left/right-TALK toPanel Right master fader Right master featuresLeft/center/right-LCR to Master Four Block Diagram Main left/ main right-L-R to Mono Mono master featuresSolo on indicator Talkback mono-TALK to MonoPanel Talkback on-TALK on Talkback featuresTalkback level Pink noiseModule Block diagram Left, right and mono output XLR’s Left and right alternate output XLR’sLeft and right monitor output jacks Matrix 1-2 output XLR’sModule Insert points-left, right, and mono DC power-inSpecifications Model 5A power supplyGround linking Power supply usagePower requirements Supply identificationPower supply Multiple power supplies in-series Console and power supply groundingRedundant power supplies D7000011 10 /12 /99