Peavey X-Four owner manual High frequency-HF

Page 57

master module 5

output EQ features

On the MASTER module block, the default sources for the four output eq’s are the AUX 5 and 6, and MATRIX 1 and 2.

By using designated assignment switches, source for the first three output eq’s can be switched over to the left, right and mono masters.The fourth eq is always fed by MATRIX 2 master.

All eq's feature four bands of equalization.

see—group module

high frequency—HF

boost / cut -15 dB boost and cut at 12kHz—shelving response.

high-mid frequency—HM

boost / cut - 15 dB boost and cut.

selectable frequency range of 400Hz to 8 kHz.

The response is bell-shaped with a fixed Q of 1.5.

low-mid frequency—LM

boost / cut - 15 dB boost and cut

selectable frequency range of 80Hz to 2 kHz.

The response is bell-shaped with a fixed Q of 1.5.

low frequency—LF

boost / cut 15 dB boost and cut @ 80Hz.

p. 57

Image 57

Contents Four mixing console Manual Table of contents Page Conventions Module Block diagram Panel Phantom power-+48V FeaturesPad LineMono input module High-pass filter-HPF GainModule EQ features 1mono input module Aux sends Aux send featuresAux 1-4, 5/6 pre-fader-PRE Aux stereo 5/6Panel Left-center-right-LCR Bus assignment featuresPan control MuteMono input module Mono input module Mono input module Peak indicator-PK Level meter featuresSignal level LED’s Signal present indicator-SIGMono input module Left / right assignment-L-R Mono assignment-MGroup 1-4 assignment Pre-fader listen-PFL1mono input module Rear panel features Stereo input module Line select-Line Left and right mono-switchesStereo input module Input gain-GAIN Stereo input module Equalizer-EQ on Four-band stereo EQ featuresPanel Stereo balance 5 and 6-STEREO Aux send 1-6 controls2stereo input module Balance control 2stereo input module Left/right assignment-L/R 2stereo input module Balance on-groups-BAL on 2stereo input module Balanced left and right line-in XLR connectors Line-input left and right RCA connectorsLine-input left and right 1/4TRS jacks Group module Mid frequency-MID Output eq featuresGroup module Group equalization -per output channel-EQ to Group Group module Matrix features Matrix 1-2 levels-M1, M2Post-group Panel Reversing aux / group and aux / main Fader reverseAux 1-6 output level After-fader listen-AFLGroup module Mono assignment-fromgroup-MONO Group assignment featuresLeft/right assignment-fromgroup-L/R PanGroup module Group/aux level features Signal/peak LED’sFader Panel Group insert point Group outputGroup insert send Group insert return Lamp dim switch and DC in connector Aux insert point Auxiliary 1-6 output XLR’sAux insert send Group inputsModule Block diagram High frequency-HF Master module Left,right,mono equalization-EQ to LEFT,TO RIGHT,TO Mono Module Left, right, and mono levels-MATRIX1-2 Post-left, post-right, post-monoExternal input levels-MATRIX1-2 Panel Matrix output features Master output levels-MTX1-2Matrix 1-2 talkback-TALK to Master module Pre switch Alternate out featuresAlternate out level Sum monoMaster module Monitor-out level Monitor output featuresSolo-off Headphone levelFour Block Diagram Signal/peak LED-SIG/PEAK Left master featuresTalkback left/right-TALK to Sum left/right-SUM L/RPanel Right master features Left/center/right-LCR to MasterRight master fader Four Block Diagram Solo on indicator Mono master featuresTalkback mono-TALK to Mono Main left/ main right-L-R to MonoPanel Talkback level Talkback featuresPink noise Talkback on-TALK onModule Block diagram Left and right monitor output jacks Left and right alternate output XLR’sMatrix 1-2 output XLR’s Left, right and mono output XLR’sModule Insert points-left, right, and mono DC power-inSpecifications Model 5A power supplyPower requirements Power supply usageSupply identification Ground linkingPower supply Console and power supply grounding Redundant power suppliesMultiple power supplies in-series D7000011 10 /12 /99