Peavey 7/9780300698 Power Amplifier Section Rated Power & Load, Frequency Response, HUM and Noise

SPECIFICATIONS:

POWER AMPLIFIER SECTION

RATED POWER & LOAD:

210W RMS into 4 ohms (with DDT™ compression)

300W RMS into 2 ohms (with DDT™ compression)

POWER AT CLIPPING (typically 5% THD, 1 kHz 120 VAC line): 130W RMS into 8 ohms

230W RMS into 4 ohms

340W RMS into 2 ohms

FREQUENCY RESPONSE:

+0, -1 dB, 100mW to 200W RMS, 20 Hz to 20 kHz into 4 ohms typically below 0.1%

THD

DDT™ :
Dynamic Range:	Greater than 20 dB
Maximum THD:	Below 0.5% THD for 6 dB overload
	Below 1% THD for 20 dB overload

HUM AND NOISE:

Greater than 105 dB below rated power

POWER CONSUMPTION:

800W, 50/60 Hz, 120 VAC

PREAMP SECTION

THE FOLLOWING SPECS ARE MEASURED AT 1 kHz WITH THE CONTROLS SET AS FOLLOWS:

-10 dB pad: out Pre Gain at 5 Post Gain at 10 Bright off (out) Contour off (in) Low set flat (0) High set flat (0)

All EQ sliders centered (0) Graphic select switch: out

Nominal levels are with Pre Gain set at 5 Minimum levels are with Pre Gain set at 10

PREAMP INPUT (Pad Out):

Impedance:	High Z, 220K ohms
Nominal input level:	-17 dBV, .14 V RMS
Minimum input level:	-37 dBV, .015 V RMS
Maximum input level:	+7.6 dBV, 2.4 V RMS
PREAMP INPUT (Pad In):
Impedance:	High Z, 44K ohms
Nominal input level:	-7.2 dBV, .435 V RMS
Minimum input level:	-26 dBV, .048 V RMS
Maximum input level:	+17.5 dBV, 7.5 V RMS

8