Peavey 7/9780300698 manual PRE-EQ Effects Patch Patch OUT, Crossover High Output, LOW Output

Page 9

PRE-EQ EFFECTS PATCH

PATCH OUT:

Function:

Low-level pre-EQ effects send

Load impedance:

1K ohms or greater

Nominal output:

-10 dBV, 0.3 V RMS

PATCH IN:

Function: Low-level pre-EQ effects return

Impedance: High Z, 220K ohms

Designed input level: -10 dBV, 0.3 V RMS

(Switching jack provides patch OUT to patch IN connection when not used)

CROSSOVER HIGH OUTPUT:

Function:

High pass out

Load impedance:

1K ohms or greater

Nominal output:

0 dBV, 1 V RMS

Maximum output:

+20 dBV, 10 V RMS

LOW OUTPUT:

 

Function:

Low pass out

Load Impedance:

1K ohms or greater

Nominal output:

0 dBV, 1 V RMS

Maximum output:

+20 dBV, 10 V RMS

PREAMP OUTPUT:

 

Function:

Full-range output

Load Impedance:

1K ohms or greater

Nominal Output:

0 dBV, 1 V RMS

Maximum output:

+20 dBV, 10 V RMS

POWER AMP INPUT:

Impedance:

High Z, 22K ohms

Input Sensitivity:

1K ohms or greater

Nominal Output:

0 dBV, 1 V RMS

(Switching jack provides preamp OUT to power amp IN connection when not used)

SYSTEM HUM AND NOISE:

(At nominal input level 20 Hz to 20 kHz unweighted) 90 dB below rated power

EQUALIZATION (7-Band, 2 1/2 octave centers with shelving):

40 Hz, 100 Hz, 250 Hz, 625 Hz, 1.6 kHz, 4 kHz, 10 kHz...All +/- 15 dB Low: Active low-frequency control, +/- 15dB shelving type.

High: Active high-frequency control, +/- 15dB shelving type.

Bright: Special high-frequency contour, +8 dB

Contour: Special EQ curve

CROSSOVER (FOR BIAMP APPLICATIONS):

Range:

100 Hz to 1 kHz

Slope:

12 dB/octave

9

Image 9
Contents Combo Cover Page Introduction FeaturesBright Switch Input PAD SwitchContour Switch Compressor Active Switch and DisplayPreamp OUT/POWER AMP Graphic IN/OUT SwitchDDT Speaker Protection System Switch Power SwitchCombo 115 Rear Panel Combo 210TX Rear Panel Ground Polarity SwitchLine Cord 120V Products only FuseRemote Switch Jack Line Mains Cord RetainerExternal Speaker Jack Power Consumption Power Amplifier Section Rated Power & LoadFrequency Response HUM and NoisePRE-EQ Effects Patch Patch OUT Power AMP InputPatch Crossover High OutputCaracterísticas IntroducciónConmutador DE PAD Atenuador fijo Enchufe Hembra Input EntradaPRE Gain Ganancia anterior al procesamiento de la señal Conmutador Bright BrilloPost Gain Ganancia posterior al procesamiento de la señal Graphic Equalizer Ecualizador gráficoCrossover Separador de frecuencias LED Indicador Status EstadoCable DE Alimentación Sólo EN Productos DE 120 V AdvertenciaRetén DEL Cable DE Línea Mains Fonctionnalites FrancaisPRE-GAIN Commutateur DE PAD D’ENTREECommutateur DE Bright Commutateur DE ContourSortie PREAMPLI/ENTREE Preampli DE Puissance DEL D’AFFICHAGE D’ETATCommutateur DU Systeme DE Protection DDT DES HAUT-PARLEURS Fusible Commutateur D’ALIMENTATIONAvertissement Commutateur DE Polarite DE TerreMerkmale EinführungEingangspufferschalter EingangsbuchseBRIGHT-SCHALTER CONTOUR-SCHALTERFrequenzweiche Graphic EQUALIZER-SCHALTERVORVERSTÄRKER-AUSGANG/LEISTUNGSVERSTÄRKER-EINGANG STATUS-LEDNetzkabel NUR 120 V-PRODUKTE NetzschalterSicherung VorsichtBuchse FÜR Fernbedienungsschalter Buchse FÜR Externen LautsprecherPeavey ONE-YEAR Limited WARRANTY/REMEDY Important Safety Instructions