Korg MICRO manual Assigning control changes, Control Change

Assigning control changes

5-1. CONTROL CHANGE ()

Assigning control changes

You can assign control change numbers to the principal parameters accessed by the EDIT SELECT 1 and 2 knobs and knobs 1–5.

When you operate a knob that corre- sponds to one of the parameters shown below, the assigned control change will be transmitted. If the microKORG receives the assigned control change, the param- eter value corresponding to that knob will be adjusted.

The default settings of these parameters are shown on page 56.

Procedure

1Hold down the SHIFT key and press

the 5 key.

The display will indicate "."

2Turn the EDIT SELECT 1 or EDIT

SELECT 2 dial to select the section that contains the parameter whose control change you want to specify.

3Turn each knob to select the desired MIDI control change number (oFF, C.00..C.95).

If the specified number is currently assigned to another parameter, the last decimal point "." in the display will light.

4When you have finished making settings, press the lit 5 key or the SHIFT key.

The microKORG will return to its normal state.

The MIDI "MIDI CH" knobs 1 and 2 will select the control change number for TIMBRE SELECT and SYNC CTRL.

1	2	3
1, 4

Parameters for which you can assign a control change

(TIMBRE SELECT)

(SYNC CTRL) (SYNC CTRL)

61