FD-6 Hi-Hat Control Pedal, Narrow Wide

FD-6 (Hi-Hat Control Pedal)/TD-8 (Percussion Sound Module)

FD-6(Hi-Hat Control Pedal)

Adjusting the Travel of the Pedal

deep

Shift the Arm

shallow

Loosen the bolt with the included tuning key. After adjusting, tighten the bolt.

Pedal Plate

Control Out Jack

Attaching the Anchor Bolts (When Using on the Carpet)

Anchor Bolt

Spring for

the Anchor Bolt

•The tips of the anchor bolts are sharp. Handle with care.

•When using on flooring, the anchor bolts may damage the floor. Do not attach the anchor bolts.

•When the FD-6 is not going to be used for a long period of time, move and fix the arm, allowing longer travel for the pedal.

•To avoid damage, do not leave the FD-6 for extended periods of time with the pedal plate depressed.

The TD-8 owner's manual assumes use of the FD-7 Hi-Hat Control Pedal. For each instance in which you find “FD-7” mentioned in the TD-8 owner's manual, please substitute the name “FD-6.”

Specifications

FD-6: Hi-Hat Control Pedal

Dimensions: 160 (W) x 395 (D) x 120 (H) mm

6-5/16 (W) x 15-9/16 (D) x 4-3/4 (H) inches

Weight: 1.4 kg

3 lbs 2 oz (including anchor bolts)

TD-8(Percussion Sound Module)

Attach the stand holder (included with the drum stand) to the TD-8.

Narrow

Wide

•To attach the stand holder, remove the four 12 mm screws (M5 x 12) from the bottom of the TD-8 and use them. Use of other screws may result in damage to the unit.

•When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient the unit so no buttons or controls get damaged.

•When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.