Roland TD-8KV Setting Pads and Pedals, Assembling the KD-80, Mount the stay on the pad, Bracket

Page 8

Setting Pads and Pedals

KD-80(V-Kick Trigger)

Before using the KD-80, you need to adjust the head tension (p. 6).

Hoop

Head

Tuning Bolt

Cushion

Sensor

T-bolt

Leg

Stand

Rubber

Foot

 

Foot

Frame

 

Output Jack

Stay

 

 

Bracket

3.Mount the stay on the pad.

Align the mark on the stay with the protrusion of the bracket, and use the tuning key to firmly tighten the bolts that you loosened in step 2.

Align the marks

Bolt

4.Loosen the leg nut.

5.Rotate the rubber foot to adjust the leg tip.

Adjust to use the spike legs when installing on carpeting or other soft surfaces, or the rubber legs when installing on flooring or other hard surfaces.

When shipped from the factory, the stand is adjusted for using the rubber legs.

Spike Leg

Rubber Leg

Assembling the KD-80

Spike

Nut

Rubber Foot

Take care not to pinch your fingers between the KD-80 pad and the stand plate.

Please be aware that by using a felt beater, you risk causing damage to the head as a result of the metal portions of the beater that can become exposed when the felt wears thin. For the kick pedal, we recommend that you use only the supplied beater, or a commercially available plastic beater.

1.Place the KD-80 pad, with the head surface facing downward, on a flat surface such as the floor.

2.Use the included tuning key to loosen the bolts for the bracket on the back of the KD-80 pad, then open the bracket.

The tip of the spike is sharp. Handle it with care.

When using on flooring, the spike legs may damage the floor. Adjust to use the rubber legs.

6.Tighten the nut and rubber foot to secure the rubber foot in place and keep it from loosening.

The nut and rubber foot must be tighten to prevent the malfunctions.

8

Image 8
Contents Page Page Page Additional Precautions PlacementMaintenance Getting Started Check the Contents of the BoxSetup Procedure Adjusting the Head Tension Use the included tuning key to tighten the tuning boltsAbout the Mesh Head KD-80 approximately 7.5 mm PD-80R/PD-80 approximately 7 mmWhen the Head Should Be Replacing the HeadReplaced About the Lock BushingsSetting Pads and Pedals Assembling the KD-80Mount the stay on the pad BracketSpecifications Adjust the striking point for the beaterTighten the T-bolts to secure the legs to the stand Lift the KD-80 and place the stand and the four legsAdjustment for Positional Sensing with the TD-8 Use the included tuning key to tighten the stopper boltPD-80R/PD-80 V-Pad Attaching the Pad to a StandOutput Jack Corresponding Tones Sounded Play Methods Playing the CY-12R/CMovement Troubleshooting PD-7 PadFD-6 Hi-Hat Control Pedal Narrow WideConnect the pads and pedals to the TD-8 Secure the cable with cable ties Connecting the CY-12R/CAbout the Included Cables Information 03012067 ’03-5-3N