Roland TD-8KV owner manual Specifications, Adjust the striking point for the beater, Upright

KD-80 (V-Kick Trigger)

7.Loosen the T-bolts for the stay and mount the legs on the stay.

Install the legs as shown in the figure so that the ends of	If you are using a kick pedal with an under plate
	Adjust the length of the legs so that the four legs of the
the legs protrude by about 1 inch (2 cm).
	KD-80 and the heel of the kick pedal contact the floor
	evenly.

13. Adjust the striking point for the beater.

The beater's striking point is adjusted to fall at the center of the head.

Adjust the striking point so that it doesn't extend beyond the cushion on the back of the head.

	When Using a Twin (Double Kick) Pedal
	With the KD-80, you can also play using a twin (double kick)
	pedal.
Extend the leg	Set this up so the striking points of the two beaters fall at equal
	distances to the left and right of the center of the head.
by about 1 inch
(2 cm).
8. Tighten the T-bolts to secure the legs to the stand.	When using a twin (double kick) pedal, as with a regular
9. Lift the KD-80 and place the stand and the four legs
	pedal, use the included beater or a plastic beater as the beater
upright.	for the kick pedal.

10. Adjust the angle of the stand plate so that it's at a right angle to the floor.

Loosen the T bolts that you tightened in step 8, and adjust the length of the legs so that the stand plate is vertical to the floor. Then firmly tighten the T bolts.

11.Install the included beater on your kick pedal.

12.Mount the kick pedal on the KD-80.

			Specifications
Adjust			KD-80: V-Kick Trigger
the leg length			Pad Size: 8 inches
		Under plate	Trigger: 1
Stand plate			Dimensions: 440 (W) x 340 (D) x 465 (H) mm
		Heel portion	17-3/8 (W) x 13-7/16 (D) x 18-5/16 (H) inches
	60°	90°	Weight: 4.8 kg
			10 lbs 10 oz

•Install the kick pedal securely.

•Set the KD-80 so no mechanical noise is heard when you step on pedal.

•Make sure that KD-80 does not touch the drum stand or the other pads.

9