Roland TD-8KV owner manual About the Included Cables, Connecting the CY-12R/C

Page 15

Connect the pads and pedals to the TD-8

About the Included Cables

Using the provided cables, connect the pads and pedals to the TD-8.

•Carefully refer to the numbers shown in the illustration and connect to the appropriate TRIGGER INPUT jacks on the TD-8’s rear panel.

•Connect the L-shaped plug of the included cable to the pad.This will prevent strain from being applied to the pad.

2 m

3.5 m

1 m

Connecting the CY-12R/C

1.Use the included cable to connect one of the CY- 12R/C’s output jacks (either one, but not both) to the TD-8's trigger input jack.

If the CY-12R/C is to be used as a crash cymbal, connect it to the BOW/EDGE output jack; if it is to be used as a ride cymbal, connect it to the BOW/BELL output jack.

2.Secure the cable with cable ties.

Secure the cables in place with the cable tie, while leaving some slack in the cables to ensure that they are not pulled by the movement of the cymbal units when struck.

Wind the cable tie twice

Leave

Tighten it not to slip

some slack

 

Turn back

to fix the cable

Secure the cable with the cable tie

Take care to ensure that the cables do not touch the cymbal units and/or the stand. A cable touching a cymbal unit or a stand may cause double sounding or other incorrect operation.

When you have finished making the connections, proceed with the

TD-8's settings.

Settings optimized for the TD-8KV are provided in factory settings on the TD-8 (Trigger Bank 1).

1.Press [SETUP] → [F1 (TRIG)].

2.Check to see if you have things set as shown in the screen below.

3.If your settings are different, make the trigger settings as described in the owner's manual provided with the TD-8.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Page Page Page Placement MaintenanceAdditional Precautions Check the Contents of the Box Setup ProcedureGetting Started KD-80 approximately 7.5 mm PD-80R/PD-80 approximately 7 mm Adjusting the Head TensionUse the included tuning key to tighten the tuning bolts About the Mesh HeadAbout the Lock Bushings When the Head Should BeReplacing the Head ReplacedBracket Setting Pads and PedalsAssembling the KD-80 Mount the stay on the padLift the KD-80 and place the stand and the four legs SpecificationsAdjust the striking point for the beater Tighten the T-bolts to secure the legs to the standAttaching the Pad to a Stand Adjustment for Positional Sensing with the TD-8Use the included tuning key to tighten the stopper bolt PD-80R/PD-80 V-PadPlaying the CY-12R/C MovementOutput Jack Corresponding Tones Sounded Play Methods PD-7 Pad TroubleshootingNarrow Wide FD-6 Hi-Hat Control PedalConnect the pads and pedals to the TD-8 Connecting the CY-12R/C About the Included CablesSecure the cable with cable ties 03012067 ’03-5-3N Information
Top Page Image Contents