Thermador CGB30RCULP, CGB48RU Lighting Instructions with Automatic Ignition, Read Before Lighting

SECTION 3: USINGYOUR CHAR GLO® BARBECUE

LIGHTING INSTRUCTIONS WITH AUTOMATIC IGNITION

– Read Before Lighting –

Main and Smoker Burners:

1.Raise hood/lid.

2.Light only one burner at a time.

3.Always turn control knob to the “Lite” position and immediately press and hold the ignition switch. The burner will light within 4 -10 seconds.

4.Release ignition switch after burner ignites. Look for the flame to check that it is lit. For the smoker burner, pull drawer open to see the flame.

5.Repeat procedures until desired number of burners are lit.

6.Adjust control knobs to the suggested preheat flame setting. Refer to the Grill Cooking Chart Pages 16 and 17.

Infrared Rotisserie Burner:

1.Raise hood/lid.

2.IMPORTANT NOTE: Make sure the control knob is set to the “LITE” position when lighting the infrared burner. Confirm that the burner has lit within 30 - 45 seconds. The flame will be blue initially.

3.Allow the burner to operate on "HI" until it begins to glow orange/red (typically 2-3 minutes) before adjusting the control knob to the desired flame setting.

3.Adjust control knob to the suggested flame setting. Refer to the Rotisserie Cooking Chart Page 20.

Side Burner/s:

1.Remove stainless steel cover; set aside.

2.Turn control knob to the “Lite” and immediately press ignition switch. The burner will light within 4 -10 seconds.

3.Adjust control knob to the desired flame setting.

Page 12