Vermont Casting 6100 owner manual HOW to Shut OFF the Grill, Locating the Match Lighting Hole

Page 29

Lighting Instructions

MATCH LIGHTING

IMPORTANT: The match lighting hole is found under the front right corner of the grill bottom. When match lighting the grill, use the gas control knob on your RIGHT-HAND side (closest to the match lighting hole).

Repeat steps 1 to 4 of “Igniter Lighting Instructions.”

STEP 5. To match light: push down and turn the RIGHT burner control knob counterclockwise to the high setting.

STEP 6.

IMMEDIATELY strike a long wooden match and position the burning match through match lighting hole in the grill bottom. Extend the flame near a burner port in the bottom edge of the burner. The burner should light.

To light the other side of the burner, press in and turn the opposite control knob. The flame will track around the burner. Allow grill to preheat with the grill lid closed for five to ten minutes before cooking.

CAUTION: Do not touch any hot grill parts. The outside of the grill bottom becomes very hot during use. It may be necessary to use protective gloves.

HOW TO SHUT OFF THE GRILL

STEP 1. Turn the burner-control knob(s) off. The burner flame will go out.

STEP 2. Turn off the top L.P. cylinder valve by turning the knob in a clockwise direction until it stops.

IMPORTANT: Always have the gas shut off at the L.P. cylinder valve when the grill is not in use. The L.P. cylinder has a leak detection feature which will restrict the amount of gas flow to the burner if the tank shut-off valve has not been turned off prior to the next use.

Locating the Match Lighting Hole

The match lighting hole is located beneath the lower right corner of the grill bottom casting.

30

Image 29
Contents Great Outdoors Table of Contents 6000,7000,8000 Series Gas Grill Portable L.P. Gas Barbecue Grills Fuel Regulator and Hose Transporting a Full Cylinder Filling and Purging Type 1 L.P. GAS Cylinders Take These Instructions to the L.P. Gas DealerExample a Filling a Type 1 Cylinder Valve Example BGetting Started Tools needed to assemble grillUnpacking the Grill Parts Liquid Propane ModelsLocate these parts Assembly Identifying the Grill PartsTools Needed Assembly Attach the Base to the PillarGrill bottom Assembly Heat Shield Back side of grill Assembly Attach Grill Bottom to PillarAssembly Step Assembly Attach the Side Tables Only for grills equipped with a side burner Side Burner InstallationPhillips head screwdriver Valve orifice properly Seated into burner tube USE Hardware BAG D Assembly Assemble the Grill LidAssembly Step No Tools are Needed Assembly Installing the Internal Grill PartsSet the warming rack onto the back of the cooking grids Installing an L.P. Gas Cylinder Connecting the Regulator to Cylinder Connecting the L.P. Gas CylinderSide Burner Option L.P. Gas Only Installation for Natural GAS Natural Gas Grills Connecting to Natural GasLeak Test Connections Operating the QUICK-CONNECTTo Disconnect the Fuel Supply Use and Care Directions Chapter How to Check the Fuel Supply System for Gas Leaks Leak TestingLighting Instructions Lighting InstructionsIgniter Lighting System Locating the Match Lighting Hole HOW to Shut OFF the GrillMatch Lighting 6000,7000,8000 Series Replacement Parts Pillar Assembly Bottom / Burner AssemblyBase Assembly Model 6100 Series ComponentsLeft Side Table Assembly Right Side Table AssemblySideburner Components Variable Components