Viking VGIQ4122RT1L, VGBQ5323RE2L, VGBQ5323RE1N Infrared Rotisserie Burner, Battery Replacement

Cleaning and Maintenance

Infrared Rotisserie Burner

Special care is not required for the infrared rotisserie burner. It

is designed as a self-contained unit. Do not attempt to clean it. Its own operation burns off any impurities which may condense on it.

		Individual part cleaning chart
	Part	What to use	How to clean
	Stainless steel*	Mild detergent and warm	Wipe with soft cloth or
		water or stainless steel	sponge. Use stainless steel
		cleaner	cleaner to remove fingerprints
			and smudges. Rinse and dry
			thoroughly.
	Porcelain parts	Mild detergent and warm	Wipe with soft cloth or
	(Grates)	water or nonabrasive	sponge. Rinse and dry
		household cleaners.	thoroughly. For stubborn
			spots, occasionally use a
			non-caustic oven cleaner
			(fume free).
	Flavor Plates	Mild detergent and	Soak in warm water and mild
		warm water or stainless	detergent. For stubborn
		steel cleaner	spots, scrub with stainless or
			brass bristle BBQ brush. Wipe
			down with heavy-duty cloth or
			sponge. Dry thoroughly.
Care	Control knobs	Mild detergent and	Wipe with soft cloth or
		warm water or	sponge. Rinse and dry
Product		nonabrasive household	thoroughly.
		cleaners. Do not soak.
	Painted parts	Mild detergent and warm	Wipe with soft cloth or
	(Canopy)	water or nonabrasive	sponge. Rinse and dry
		household cleaners	thoroughly.

*NOTE: Under rare conditions, such as an extremely salty environment, small amounts of rust may accumulate on stainless steel parts. These small amounts of surface rust can easily be removed by applying Soft Scrub® Gel to a damp sponge and wiping with the stainless steel grain. It is important to make sure you wipe with the grain for the most efficient removal of surface rust.

Cleaning and Maintenance

Battery Replacement

Each T-Series grill is equipped with a battery for the electronic ignition. The 30”W. models only have one battery located under the left hand side of the control panel. All other models have two batteries located under each end of the control panel. The battery locations are shown on the control panel. To replace the battery:

1.Slide out drip tray.

2.Locate round black cap, which is inside the burner box under the battery symbol on the control panel.

3.Unscrew cap. Battery is snapped in the cap.

4.Replace the battery by connecting corresponding post to post inside burner box.

5.Snap cap on battery and screw back into slot underneath control panel.

Battery	Product Care
Battery
cap

NOTE: Round black cap that holds battery is located underneath control panel and behind drip tray.

28 29