Product Care
Cleaning and Maintenance
ReplacingInterior Halogen Canopy Lights
CAUTION
DISCONNECT THE ELECTRIC POWER BEFORE REPLACING BULB.
Do not touch bulb with bare hands. Clean off any signs of oil from the bulb and handlewith a soft cloth.
|
| glass light |
1. | Unsnap glass light cover | cover |
| ||
| using a screwdriver in the |
|
| access groove. | access |
|
| |
2. | Firmly grasp light bulb and | groove |
| pull out. |
|
3. | Replace with halogen bulb |
|
| using volt and wattage | light |
| requirements listed on glass | bulb |
| cover. |
|
4. Replace the light cover by snapping glass cover onto metal box.
5. Reconnect power.
Spider Inspection
You should inspect the burners/venturi tubes at least once a year, or immediately if any of the following conditions occur.
•The smell of gas along with the burner flames appearing yellow.
•The grill does not reach the proper temperatures.
•The grill heats unevenly.
•The burners make a popping noise.
WARNING
SPIDER AND INSECT INFESTATION
Spiders and insects can nest in the burners/venturi tubes of this or any other grill, and cause the gas to flow from the front of the burner. This is a very dangerous condition that can cause a fire to occur behind the valve panel, thereby damaging the grill and making it unsafe to operate.
Troubleshooting
PROBLEM | POSSIBLE CAUSE AND/OR REMEDY |
|
|
|
|
|
|
Make sure the control knob is off (no gas |
|
| |
the ignitor is pressed | is on). Remove the grill rack and the flavor |
|
|
| generator plates. Watch the ignitor tip. You |
|
|
| should see a spark jump from the tip of the |
|
|
| ignitor when the button is pressed. Do the |
|
|
| other burners work? Make sure the ignitor |
|
|
| tip is clean and free from debris. Check |
|
|
| battery to electronic ignition. |
|
|
|
|
|
|
Burner flame is yellow or | Check the burner inlet for obstructions. |
|
|
orange and a gas odor is | Check the air shutter for proper adjustment. |
|
|
present |
|
|
|
|
|
|
|
Low heat with knob on | Is the fuel hose bent or kinked? Is there |
|
|
“HIGH” | adequate gas supply available? If only one |
|
|
| burner appears low, does the orifice or |
|
|
| burner need cleaning? Are any other gas |
|
|
| appliances at the location below normal |
|
|
| rate? Is the air shutter too far open or |
|
|
| closed? Is the gas supply or gas |
|
|
| pressure low? |
|
|
|
|
|
|
Burner will not light | Is there a spark at the thermocouple? Can |
|
|
| you match light the burner using the flame |
|
|
| parts? |
|
|
|
| ||
Burner lights, but will not | Is the thermocouple kinked or bent away |
|
|
hold flame once button is | from the burner? Readjust to lay flat against |
|
|
released | burner. Is the safety valve button being |
|
|
| depressed long enough? Hold button in |
|
|
| until burner remains lit. Check for black |
| Product |
| spots on the infrared screen. |
| |
|
|
| |
|
|
|
|
If your grill rotisserie should | Is the electrical cord securely inserted in the |
|
|
fail to operate | electrical outlet? Is the circuit breaker open, |
| Care |
| or is a fuse blown? |
| |
|
|
| |
|
|
|
|
|
|
|
|
30 | 31 |