Operation
Lighting Grill
T-Series Models
When lighting a burner, always pay close attention to what you are doing. Be certain you are pressing the battery ignition button
Electronic 
ignitor 
Grill burner control knob
Side burner control knob
Rotisserie control knob
NOTE: Control locations will vary according to model.
Lighting Grill Burners
Open the hood or remove covers. Push and turn the control knob until the “HIGH” position on the knob aligns with the indicator line on the control panel. Press the electronic ignition button corresponding to the burner being lit. You will hear a clicking sound. Turn the control knob to the desired setting. If the burner does not light in 4 seconds, turn the knob to “OFF” and wait 5 minutes before trying again. This will allow accumulated gas to dissipate. After several failed attempts the burner can be lit with a paper book match using the flash tubes. If you have just attempted to light the burner with the ignitor, allow 5 minutes for any accumulated gas to dissipate.
Flash tube 
Lighting Grill
Place the lit match through the grid next to the flash tube of the burner being lit. Keep your face as far away from the grill as possible. Make sure the match is adjacent to the flash tube. Push and turn the control knob until the “HIGH” position on the knob aligns with the indicator line on the control panel. Make sure you are turning the control knob that corresponds with the burner being lit. If the burner does not light in 4 seconds, turn the knob to “OFF,” wait 5 minutes, and try again. If the burner will not light after several attempts, see the Troubleshooting section.
Lighting TruSear™ Infrared Burner (If Applicable)
Before lighting the burner, remove the stainless steel cover. Push in and turn the TruSear™ infrared control knob until the “HIGH” position on the knob aligns with the indicator line on the control panel. Press the electronic ignition button that corresponds to the control knob. You will hear a clicking sound. Once lit, turn the control knob to the desired setting. If the burner does not light within 4 seconds, release and turn the control knob to “OFF.” Wait 5 minutes for any accumulated gas to dissipate and try again. After several failed attempts, the burner may be lit by turning the control knob to “HIGH” and dropping a match on the face of the burner. If the burner does not immediately ignite, turn the knob to “OFF”, wait 5 minutes and try again.
Lighting Side Burners
First, remove the burner cover or any cooking utensil from the burner grate.
CAUTION
The side burner cover may be hot if the grill burners are in operation.
Push and turn the control knob until the “HIGH” position aligns with the indicator line on the control panel. Immediately press the electronic ignition button corresponding to the burner(s) being lit until the burner is lit or until 4 seconds pass. If the burner does not light after several attempts, wait five minutes to allow any accumulated gas to dissipate. If the burner will not light after several attempts, then the burner can be lit by holding a lit match next to the burner ports. Push and turn the control knob until the “HIGH” position on the knob aligns with the indicator line on the control panel.
Operation
12 | 13 |