Troubleshooting, Problem Possible Cause | Meco 2400, 2420, 2440, 2430

e) Unzip the Grill Cover and lay it out flat as shown. (FIG. 19E) With grill legs folded under the grill, place the grill on the grill cover.

f)Unzip the pocket in the grill cover and place Lantern inside as shown. (FIG. 19F) Zip the Lantern pocket.

g)Carefully fold over the grill cover flap, allowing the Lantern to rest on top of the body above the left leg. Zip the grill cover and allow the handle to protrude through the opening of the grill cover. The grill can be transported and stored in a compact manner. (FIG. 19G)

5)Before using the grill, after periods of storage or non-use (i.e. over winter), check your LP gas grill for gas leaks, deterioration, proper assembly, and burner obstructions.

6)Periodically check and tighten all nuts, bolts, and screws. Make sure all electrode and ground wires are not loose.

Lantern zip pocket

Lantern will rest here when cover is folded over

FIG. 19E

Lantern in pocket

FIG. 19F

FIG. 19G

TROUBLESHOOTING

Problem:

Possible Cause:

Solution:

Burner will not light using the Ignitor

Burner is not connected to Valve.

Not pausing long enough before clicking the Ignitor

No spark

LP gas cylinder is empty

1 lb. Cylinder Coupling Nut not fully connected

LP Excess flow valve tripped in regulator

Make sure burner tube is over the gas nozzle. See How to Clean the Burners #6 page 17: Re-install after cleaning.

When lighting the Burner, push-in and turn control panel knob counter-clockwise to the high position. Pause 4 seconds, then Push in Ignitor button several times so that it clicks each time.

Gas collector tab is bent (making too large or small of a gap between electrode and tab). By hand, bend gas collector tab to approximately 3/16” gap to electrode. (See page 13 & 14 for illustrations). NOTE: Be very careful adjusting Side Burner electrode gap. The Ceramic can break.

Make sure gas Collector, Ignitor and electrodes are tight. Make sure electrode wires and ground wire are connected to Ignitor.

Replace 1 pound disposable cylinder.

Tighten 1 pound Cylinder or coupling nut by hand. Do not use tools.

Turn control knob to “Off” position. Wait five minutes. Relight LP gas grill. If flame remains to be low, turn off gas at the grill. Disconnect the regulator from the LP gas cylinder. Reconnect the regulator to the LP gas cylinder. Perform a leak test; rlight grill. This will reset the excess flow valve.