Install Grease Container

STEP 3) Assemble Lantern and Gas Tube: Insert the gas tube into the lantern nozzle. (FIG. 7A) Engage the knurled coupling into the lantern and turn until snug. (FIG. 7B) Be careful not to cross thread the connection.


	FIG. 7A				FIG. 7B

STEP 4) Assemble Lantern & Tube to Grill: Remove the gas tube clip from under the leg by loosening the two screws securing it. (This is for store display grills and not needed for your use.) Just re-tighten the screws into the leg. (FIG. 7C)

Remove Lantern Gas Tube

Clip attached to inside leg.

FIG. 7C

Insert Gas

Tube into

PTOTM

FIG. 7D

Insert the crooked end of the Lantern gas tube into

the rear leg PTOTM opening. (FIG. 7D) Note: In order for the Lantern gas tube to be upright, it must be secured to the LP cylinder and the cylinder must be secured in the leg holder. You may delay gas tube installation until instructed on pages 10 & 11 or proceed there now to secure the gas tube.

Rotate the Lantern head around the gas tube to the desired position for access and use. Make sure gas tube is turned properly to allow hood to open.

To reduce the risk of serious bodily injury or death:

·Always burn portable lantern on a flat level surface in an upright position away from any flammable substances.

·When carrying Portable Lantern, hold it away from you and do not run with it.

·Do not use gas tube with Lantern and 1 pound LP cylinder when using Lantern as a portable light. It is not stable and will cause lantern to fall over.

·To prevent being knocked over, always disconnect lantern and LP cylinder before storing.

·Do not allow children to use the portable lantern. Keep bystanders, children and pets away from the lantern.

STEP 5) Portable Use of Lantern:

Lantern can be connected to a 1 lb. cylinder for use as a portable light. (FIG. 7G) Hold the Lantern with one hand. Insert the LP cylinder into the Lantern nozzle with other hand. Turn LP cylinder until snug. Follow leak test procedure on page 12 before using.

FIG. 7G

To reduce the risk of serious bodily injury or death:

·Never light the LP gas grill without the Grease Container in place.

From underneath the grill, align the tab and Grease Container opening with that in the bottom of the Bowl. (FIG. 8A) Push the Grease Container in and rotate the V-shape end until it locks into position under the bracket in the Bowl bottom. (Fig. 8B)


					FIG. 8B
	FIG. 8A				FIG. 8B