Step 5
With the help of a friend, set the unit upright. Try to minimize stress on the legs of the grill.
Step 6
Attach hood stops to the outside back of the body using 6 x 12 mm Phillips hex head screws. Thread screws into welded nuts and tighten until secure.
Step 7
Attach the hinges (with the spine side out) to the outside back of the body using 6 x 12 mm Phillips hex head screws. Thread screws into welded nuts but do not tighten at this point. Place lid over the body and attach hinges to the outside back of the lid using 6 x 12 mm Phillips hex head screws. Thread screws into welded nuts. Tighten all hinge screws on lid and body until secure.
Step 8
Attach handle to the lid using 5 x 75mm screws, flat washers, spacers, spring washers and nuts. The heads of the screws should be slightly recessed into the wooden handle when fully tightened.
Hood
Hinge
Hood
Stop
6 x 50mm
Screws
5