c lean it with hot soapy water or an
Also, check the tray after rain. If you’ve left the grill uncovered, you may need to remove the drip tray drain plug to drain the water from the tray. The drain plug can be removed with a
warning
DO NOT ALLOW EXCESS
GREASE OR LIQUIDS TO
ACCUMULATE IN THE DRIP 
TRAY AS THIS MAY CREATE
A FIRE HAZARD.
NEVER USE GRILL WITHOUT 
DRIP TRAY PROPERLY IN 
STALLED
g rilling rACKs
The easiest way to clean the grill racks is to do so
immediately after turning off the burners, while they are still hot. Wearing a long BBQ mitt to protect your hand from steam, dip a brass bristle brush in hot water and scrub the grill rack. d ip the brush frequently because the steam helps remove
c ERAm I c BRIQUETTES
The ceramic briquettes normally burn off any accu
mulated food drippings. But you may occasionally experi ence larger spills that don’t burn off under normal use.
When this happens, let the grill cool completely.
Remove the racks and then the briquette trays by lifting the front edge and pulling them toward you.
p the trays er and put m back in ce over the rner. Light burners
d set them “ hi ” for 5 0 minutes
to burn the briquettes clean. Any remaining food items can be brushed off using a soft brush.
Be sure the trays have com pletely cooled before reinstall ing them.
Replacement briquette trays can be ordered from Lynx or from your dealer.
mAI n BRASS BURn ERS
m ake sure the grill is com pletely cool before pro
ceeding.
Ensure that the gas supply is off and all control knobs are in the “ off ” position.
to remove b rass b urners:
1)Remove the grill racks and briquette trays.
) Lift the burner up until the legs exit the frame.
| all | the | way |
venturi |
| ||
|
| ||
|
|
| |
in |
|
|
|
Legs in slot
b urner sitting flat
the grill so the burner head comes off the brass orifice at
the front.
) Angle the burner sideways and lift it out.
Be careful not to change the air shutter position.
to Clean the b rass b urner:
To maximize grill perfor mance, clean the exterior of the burner with a wire brush. Remove stubborn scale with a metal scraper.
c lear any clogged ports with a straightened paper clip. n ever use a wooden toothpick as
it may break off and clog the
port.
Shake out any debris through the air shutter.
u se a flashlight to inspect the burner inlet to ensure it is not blocked. If obstructions can be seen, clean it with a paper clip or a pipe cleaner.
warning
PROPER PLACEMENT OF
EACH BURNER IS CRITICAL. 
AFTER CLEANING THEY
MUST BE CENTERED ON
THE BRASS ORIFICE, REST
ING LEVEL WITHOUT ANY 
ROCKING.
FAILURE TO MEET THESE
CONDITIONS MAY CAUSE 
A VERY DANGEROUS CON 
DITION THAT CAN CAUSE 
PERSONAL INJURY AND
PROPERTY DAMAGE.
17