Burner eXT inguishes

►loCATion

first determine if the problem is being caused by location. If the grill is subject to high winds, reposition it to provide some protection.

►c h Ec K Th E fLAm E

check the gas supply and flame characteristics. (See

indeX: “ f lame, Correct s ize”)

►B URn ERS S EATEd

check to ensure that the burners are correctly posi tioned in the grill. (See I nd EX: b urner Placement” for further

details.)

Correctly-installed burners should be seated firmly and level with no side-to-side

movement.

b urner eXT inguishes only when seT To

low

The valves on the grill feature an adjustable low setting.

f luctuations in gas pressure, gas conversion and even in the quality of the gas itself may affect burner perfor mance at the “ low” setting. It could be either too high or too low. (see indeX: “ b urner Adjustment” for further details.)

roT isserie won’T ligh T

follow the same procedure as described for the grill burners to diagnose problems with the rotisserie burner.

BE cARE f UL! The rotisserie burner flame may be hard to see in bright sunny conditions.

roT isserie ligh Ts buT goes ouT As soon As Con T rol is RELEASE d

►ch Ec K

TherM oCou P le

The control knob must be held in for 30 to 60 seconds after ignition for the rotis serie burner to stay lit. (See

indeX: “ lighting the rotisserie” for further details.)

If the burner will not stay lit when you release the control knob, re-light it and hold the control knob in for at least

60 seconds to allow the ther- mocouple to heat up.

If, after holding the control knob in for at least 60 seconds, the burner still will not stay lit when releasing the control knob, call for service.

(see indeX: “ o btaining service from lynx” for further details.)

ligh Ts won’T ligh T

►CheCK Power

Ensure that the grill is connected to a live Ac power source and check for rotisserie motor operation.

►reseT TrAnsfor M er

d isconnect power from the grill and wait 5 minutes for the transformer to cool down and reset. Then reconnect power. If, after resetting the transformer and replacing bulbs, you still do not have power, call for service.

►re P lAC e The b ulb

Replacement bulbs are halogen, 12 volt, 10 max, T type with a

g 4 bi-pin base.

The glass cover is held in place by two spring tension tabs. You may have to loosen the screw to remove the lens.

Avoid touching the glass of a new bulb. h alogen bulbs are very sensitive to the oils found in human skin. Touching the bulbs may shorten their life.

Pull on sPrIng tabs to release lIght Cover

the socket without twisting.

The 27” and 30”grills each have one halogen light fixture; all other grills have two light fixtures.

h old the bulb using a paper towel or other cloth and gently press it straight into the socket. The glass cover should be gently snapped back into place.