Installation Instructions
Before you start - please read the instructions carefully - planning your installation will save you time and effort.
Look at the different ways the appliance can be installed - as shown on the following pages - and plan the installation to suit your situation.
Leave the appliance in the base tray packaging until you are ready to install it. When you remove the appliance from the base tray packaging, take care not to damage it.
Whilst every care is taken to eliminate burrs and raw edges from this product, please take care when handling - we recommend the use of protective gloves during installation.
Please note that the weight of this appliance is approximately 47kg(unpacked).Take care when lifting it into the housing unit - always use an appropriate method of lifting.
This appliance must be installed only at low level - ie; under a worktop. The controls have been designed for viewing at a low level, and it should therefore not be installed at high level.
Please note that all dimensions and sizes given are nominal, some variation is to be expected.
If this appliance is to be installed near to a corner where the adjacent cabinets run at right angles forward of the appliance, there must be a gap of at least 90mm between the appliance and the cabinets, to prevent overheating of the cabinets.
Important: Do not modify the outer panels of this appliance in any way.
Fixing screws - The fixing screws are in a polythene bag in the oven pack. Depending on the method of installation, some of the screws may not be needed.
Step 1: Prepare for installation
There are 3 methods of installing the appliance:
Method 1: Into a space between two base units, ie; without a housing unit.
Method 2: Into a housing unit, with an internal height of less than 710mm, which can be modified to obtain the required dimensions.
Method 3: Into a housing unit, with an internal height of 710mm or more.
If you have a non standard size of cabinet which leaves a gap above or below the appliance, you may be able to buy a trim kit (to fill in the gap) from the supplier of your cabinets.
Quantity | Colour | Description | For Fixing: |
|
|
|
|
6 | Silver | No 8 x 12mm long | Runners to appliance |
|
| Self tapping screw |
|
|
|
|
|
12 | Black | No 8 x 12mm long | Runners and sidetrims to cabinet |
|
| Chipboard screw | or housing |
|
|
|
|
6 | Black | No 8 x 25mm long | Appliance to cabinet |
|
| Chipboard screw |
|
|
|
|
|
2 | Silver | No 8 x 12mm long | Appliance to sidetrims |
|
| Self tapping screw |
|
|
|
|
|
25