Installation Instructions
Step 4: Secure appliance into housing unit
Note: The unit housing the appliance must be appropriately fixed.
Method 1: Care must be taken to ensure the appliance runners are sufficiently engaged over the top of the runners on the base units.
Method 2: Insert appliance into cabinet - ensure that it is engaged over the top of the side runners.
Method3: Insertappliance into cabinet.
Tosecure appliancetohousingunit
Note: Ensure that the appliance is centrally located. Take care not to damage the appliance or cabinet.
Note: For installation Method 1, you will need to drill through the fixing holes into the side trims with a 3.2mm diameter drill.
There are 6 securing screws.
■Open the grill / top oven door, and screw 2 screws through the top corner holes in the front frame.
■With the grill / top oven door still open, screw 2 screws through the holes in the front frame, located under the grill compartment.
Close the grill / top oven door.
■Open the main oven door, and screw the remaining 2 screws through the bottom corner holes in the front frame.
Close the main oven door.
Step 5: Installing a hob above the appliance
When the appliance is installed under a worktop, with a hob installed above it, the installation instructions for the hob must be read in conjunction with these instructions.
When installing a gas hob above the appliance, care must be taken to ensure that the hob inlet pipe is as close to the back wall as possible, so that it does not obstruct the appliance or the appliance inlet pipe.
If a flexible inlet pipe is used, it must hang vertically and not be trapped between the oven and rear wall.
Important: - ensure that you route all mains and electrical cables and flexible tubing well clear of any adjacent heat source, such as an oven, grill or hob.
35