HSN_TriGrillManual0050 9/12/08 12:10 PM Page 13
Removing Plates
WARNING: To prevent a serious burn injury, always ensure that your
With your unit in the open position, remove the LOWER plate by pressing the LOWER plate lock button located on the right side of the unit. (see fig. 11) while lifting the plate up and towards you.
figure 11
With your unit in the open position, press down on the UPPER plate lock button located in the center front of your unit while keeping one hand on the plate itself. (see fig. 12). Guide the plate forward with your hand and lift up to remove.
figure 12
13
Helpful Hints
•Be sure to always wash the grill plates after each use to remove any residue that may have accumulated.
•Do not use sharp objects or attempt to cut food on top of the grill plates.
•Always preheat for 10 minutes until the green ready light illuminates before use. Have all ingredients in place before cooking starts.
•For best results, spread mayonnaise on both outer sides of panini sandwiches before cooking. This will give darker, crustier grill marks on the bread.
•Do not use metal utensils, as this may damage the nonstick surface of the grill plates.
•If additional sandwiches are desired, lower the lid to preserve the heat while you prepare the additional sandwiches.
•Let sandwiches cool slightly before eating. Cheese especially, becomes very hot. Soft or melted fillings will firm slightly.
•For cheeseburgers, simply grill the hamburgers in the FLOAT
or FLAT position. Once complete, open the grill and add cheese. Then select the FIXED HEIGHT position to melt the cheese.
Care and Cleaning
Other than the cleaning mentioned in this manual, no other servicing or maintenance of this appliance is required. Repairs, if necessary must be performed by an authorized service center.
WARNING: Do not immerse the appliance, cord or plug in water. Before cleaning and when finished using your appliance, unplug power cord from outlet and allow to cool completely.
Remove the grill plates according to the instructions referenced in the “Assembling and Removing Plates” section on pages
Do not use steel wool or scouring pads. Do not use abrasive cleansers. Wipe the exterior with a clean, damp cloth. Dry all parts thoroughly before using again or storing.
14