KitchenAid KSBN220PSS Product Dimensions, Enclosure Cutout Dimensions, Tools and parts

Product Dimensions

12"

(30.5 cm)

13-1/4"

(33.7 cm)

26" (66.0 cm)

25-1/2" (64.8 cm)

1/2"

male NPT

21-3/8" (54.3 cm)

3-1/2"

(8.9 cm)

Enclosure Cutout Dimensions

Enclosure and clearance dimensions that are shown must be used. Given dimensions provide required clearances.

The installation of this Side Burner must conform with the current standards CSA-Z21.58a-1998*, or with local codes.

The side burner drops into the enclosure opening and is supported by its side flanges. No bottom support is needed.

Copies of the standards listed may be obtained from:

* CSA International

8501 East Pleasant Valley Rd. Cleveland, Ohio 44131-5575

12" (30.5 cm) minimum to grill

or any accessory 12-1/8"(30.8 cm)

2-1/4"

(5.7 cm)

7-1/8"

(18.1 cm)

10-5/8"

(27.0 cm)

22-1/2"

(57.2 cm)

gas line

location at rear of side burner

35-1/2"

(90.2 cm)

counter or support surfaces

must be level

Tools and parts

Tools needed:

•level

•small flat-blade screwdriver

•flat-blade screwdriver

•Phillips screwdriver

•tape measure or ruler

•slip-joint pliers

•pipe wrench

Parts needed:

•gas line shutoff valve

•1/2" male pipe thread nipple for connection to pressure regulator

•L.P. gas-resistant pipe-joint compound

•AGA or CSA design-certified outdoor flexible stainless steel appliance connector

[4-5 ft. (1.2-1.5 m)] or rigid gas supply line as needed

•non-corrosive leak detection solution

Parts supplied

•convertible regulator set for 4" W.C. natural gas

4