KitchenAid KBZU122VSS Installation Requirements, Tools and Parts, Parts Supplied, Parts Needed

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

20 lb LP Gas Models (KBZU122VSS00)

Tools Needed

■	Tape measure	■	Wrench or pliers
■	Small, flat-blade screwdriver	■	Pipe wrench
■	Flat-blade screwdriver	■	Scissors or cutting pliers
■ #2 and #3 Phillips screwdriver			(to remove tiedowns)
			Noncorrosive leak-
■	Level	■
			detection solution

Parts Supplied

■Gas pressure regulator/hose assembly set for 11" WCP LP gas (attached to manifold)

■1 single-prong plug/2,085 mAmp transformer assembly

■Convertible regulator set for 4" WCP Natural gas

■Orifices for Natural gas conversion

■LP gas fuel tank tray

Parts Needed

■20 lb LP gas fuel tank - approximately 18" (45.7 cm) height and 12" (30.5 cm) diameter

■Mounting hardware for attaching the tank tray mounting brackets to the base or floor of the island

■Mounting hardware for attaching the power transformer to a noncombustible surface inside the island cabinet

■3-prong outdoor GFI outlet

■A bracket or shelf large enough to keep a second 20 lb LP tank from being stored in the storage area.

Natural Gas Models (KBZU122TSS00, KBZU242TSS00 and KBZU122VSS01)

Tools Needed

■	Tape measure	■	Wrench or pliers
■	Small, flat-blade screwdriver	■	Pipe wrench
■	Flat-blade screwdriver	■	Scissors or cutting pliers
■ #2 and #3 Phillips screwdriver			(to remove tiedowns)
			Noncorrosive leak-
■	Level	■
			detection solution

Parts Needed

■Gas line shutoff valve

■½" male pipe thread nipple for connection to pressure regulator

■LP gas-resistant pipe-joint compound

■CSA design-certified outdoor flexible stainless steel appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply line as needed.

Parts Supplied

■Convertible regulator set for 4" WCP Natural gas.

■Single-prong plug/2,085 mAmp transformer assembly

5