Napoleon Fireplaces BGP42 manual BGD42 Table of Contents

2

BGD42 TABLE of CONTENTS

PG 2-4 INTRODUCTION	20-22	FINISHING
Warranty		Door, Louvre & Panel Removal & Installation
General Instructions		Grate Installation
General Information		Log Placement / Glowing Embers
Care of Glass & Plated Parts		Vermiculite
Installation Overview		Charcoal Embers
6 - 13 VENTING		Charcoal Lumps
	22	OPTIONAL BLOWER INSTALLATION
Venting Lengths
	22-23	OPTIONAL FAN INSTALLATION /
Air Terminal Locations
Typical Vent Installations		GD36 THERMOSTATIC SENSOR CON-
Special Vent Installations		TROL
14 - 20 INSTALLATION
	23	OPERATION / MAINTENANCE
Wall and ceiling protection
Horizontal Installation		Operating Instructions
		Maintenance
Adjustable Firestop
Vertical Installation	24	ADJUSTMENTS
Wall and Ceiling Protection		Pilot Burner Adjustment
Using Flexible Vent Components
		Venturi Adjustment
Fireplace Vent Connection
	25-26	REPLACEMENTS
Using Rigid Vent Components
Restricting Vertical Vents		Ordering Replacement Parts
Gas Installation
		Replacement Parts
Optional Wall Switch Installation
		Vent Kits
Mobile Home Installation
		Terminal Kits
Framing
		Accessories
Nailing Tab Installation
	27-28	TROUBLE SHOOTING GUIDE
Minimum Mantel and Enclosure Clearances

PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE

!WARNING

•Do not burn wood or other materials in this fireplace.

•Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the fireplace.

•Clothing or other flammable material should not be placed on or near the fireplace.

•Due to high temperatures, the fireplace should be located out of traffic and away from furniture and draperies.

•Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.

•Even after the fireplace is out, the glass and/or screen will remain hot for an extended period of time.

•Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens and guards must be fastened to the floor.

•Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.

•It is imperative that the control compartments, burners and circulating blower and its passageway in the fireplace and venting system are kept clean. The fireplace and its venting system should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The fireplace area must be kept clear and free from combustible materials, gasoline and other flammable vapours and liquids.

•Under no circumstances should this fireplace be modified.

•This fireplace must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.

•Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and to replace any part of the control system and any gas control which has been under water.

•Do not operate the fireplace with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.

•Do not strike or slam shut the fireplace glass door.

•This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.

•Pressure relief doors must be kept closed while the fireplace is operating to prevent exhaust fumes containing carbon monox- ide, from entering into the home. Temperatures of the exhaust escaping through these openings can also cause the surrounding combustible materials to overheat and catch fire.

•Only doors / optional fronts certified with the unit are to be installed on the appliance.

NOTE: changes, other than editorial, are denoted by a vertical line in the margin.

W415-0381 / H / 12.07.07