Wall Mounting Instructions:
1. Using the two holes provided in the vertical tube, mount the bracket to the wall.
2.Ensure minimum clearance to combustibles are maintained, 4” (100mm) to sides, and 6”(150mm) from the rear.
3. Do not locate the grill under unprotected combustible construction.
4.The platform may be swivelled by removing the two #8 x 3/8” flathead phillips screws and turning the platform to the desired angle. Replace the two screws and tighten.
5.Once the platform is located in the desired position, the grill can be mounted:
a. Lock the lid of the grill closed with the latch.
b. Hold the grill by the handle with one hand, place the other hand under the grill in the
centre of the front tapered surface.
c. Place the grill bottom on the platform and slide it forward to engage the tab protruding from the bottom of the grill. Ensure that the tab is properly engaged.
d. When the dimples on the bottom of the unit line up with the holes on the platform, the latch is ready to be fastened.
6.Once the grill has been attached, thread the regulator (clockwise) into the regulator mount. On tube burner version, lift the burner slightly to align it with the orifice. Tighten by hand.
7.To fasten the regulator locking bracket, locate it at the bottom back corner of the regulator mount and turn the regulator until the gas inlet is aligned with the hole in the regulator locking bracket. Slide the locking bracket forward until the two tabs engage into the slots on the regulator mount. Tap in firmly.
8.Attach the cylinder to the regulator by turning clockwise. (Be sure not to cross thread the cylinder.)
Trailer Ball Mounting Instructions:
1. Place the ball mount over the ball on your drawbar or bumper.
2.Tighten the two wing screws until the mount is firmly held in place.
3. Once the mounting arm is tight, the grill can be mounted: a. Lock the lid of the grill closed with the latch.
b. Hold the grill by the handle with one hand, place the other hand under the grill in the centre of the front tapered surface.
c. Place the grill bottom on the platform and slide it forward to
engage the tab protruding from the bottom of the grill. Ensure that the tab is properly engaged.
d. When the dimples on the bottom of the unit line up with the holes on the platform, the latch is ready to be fastened.
4.Once the grill has been attached, thread the regulator (clockwise) into the regulator mount. On tube burner version, lift the burner slightly to align it with the orifice. Tighten by hand.
5.To fasten the regulator locking bracket, locate it at the bottom back corner of the regulator mount and turn the regulator until the gas inlet is aligned with the hole in the regulator locking bracket. Slide the locking bracket forward until the two tabs engage into the slots on the regulator mount. Tap in firmly.
6.Attach the cylinder to the regulator by turning clockwise. (Be sure not to cross thread the cylinder.)
24