For all portable outdoor grills:
1.Lift off grill grates and set aside.
2. Remove sear plates and set aside.
sear plate
3. Remove tiedowns from burners and warming shelf.
warming shelf
remove
tiedowns
remove
tiedowns burner
4. Reinstall sear plates. Make sure sear plates are resting on pins.
pins
Make gas connections
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor” gas supply line.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and authorized service personnel.
Failure to do so can result in death, explosion, or fire.
L.P./Propane: A 20 lb. L.P. tank must be purchased separately. Install the tank into the compartment below the grill and screw the hose/regulator assembly to tank as shown.
The pressure regulator and hose assembly supplied with the grill must be used. Replacement pressure
regulator and hose assembly specific to your model, is available from your outdoor grill dealer.
If converting to natural gas, see conversion kit require- ments and “Gas Supply Requirements” section. Follow instructions included with kit.
1. Turn on the gas supply. Wait a few minutes for gas to move through the gas line.
2.Test all connections by brushing on an approved noncorrosive
3.The ignitor battery is not factory installed. A 9 volt alkaline battery is located in the accessory box on the grill grate. Install battery at this time per the instructions in “Replacing the Ignitor Battery” section.
4.Go to “Check and Adjust the Burners” section.
9