Hearth and Home Technologies BIR50 Listings and Code Approvals, Required Components Include

North Star

EPA Certified Fireplace

A. LISTINGS AND CODE APPROVALS

This fireplace system has been tested and listed in accordance with UL127 and ULC-S610-M87 standards, and has been listed by OMNI Test Laboratories, Inc., for installation and operation in the United States and Canada as described in this manual. The North Star Fireplace is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is provided. The structural integrity of the mobile home floor, ceiling, and walls must be maintained. The fireplace must be properly grounded to the frame of the mobile home. Outside Air must be installed in a mobile home installation.

This fireplace has been tested and listed for use with the SL-300 Series chimney and fireplace components listed on page 7.

Check with your local building code agency before you begin your installation to ensure compliance with local codes, including the need for permits and follow-up inspections. Be sure local building codes do not supersede UL specifications and always obtain a building permit so that insurance protection benefits cannot be unexpectedly cancelled.

If you need assistance during installation, please contact your local dealer. For the number of your nearest Heat-N-Glo dealer, please call 1-888-427-3973.

Heat-N-Glo® is a registered trademark of Hearth & Home Technologies, Division of HON INDUSTRIES.

WARNING!

This fireplace and its components are designed to be installed and operated as a system. Any alteration to or substitution for items in this system, unless allowed by these installation instructions, will void the OMNI Test Laboratories, Inc., listing and may void the product warranty. It may also create a hazardous installation. Read through these instructions thoroughly before starting your installation and follow them carefully throughout your project.

B. DESCRIPTION OF THE FIREPLACE

SYSTEM

1.The fireplace system consists of the following:

a.Fireplace

b.Firebrick

c.Chimney Termination Cap

d.Chimney System

e.Hearth Extension

f.Outside Air

2.Required Components Include:

a.Chimney Air Kit

3.Optional Components Include:

a.Fire Screen

b.Lintel Bar

c.Heat Zone Kit

NOTE: Illustrations used throughout these instructions reflect “typical installations” and are for design purposes only. Actual installation may vary slightly due to individual design preferences. However, minimum clearances must be maintained at all times.

The illustrations and diagrams used throughout these installation instructions are not drawn to scale.

Figure 3A - Typical Fireplace System

4-03 3 480-1081