Extension Cord

® VMH26PRA

COMPACT CLASSIC HEARTH FIREPLACE

INSTALLATION

Continued

8. Reconnect red wire to switch position

3. Reconnect blue wire to switch posi-

tion 1. Reconnect green and white wires.

9. Install the switch plate on the valve cover

shield with 2 #10 screws provided (see

Figure 17). Route power cord out of the

cabinet by inserting it through the bush-

ing on the outer casing (see Figure 16,

page 11). Plug fan kit into 120-Volt

grounded power supply and test opera-

tion. Note: When switch is in the AUTO

position, the fan will start after the heater

has run for a few moments. The fan will

continue to run for several moments af-

ter the heater has been turned off. When

1.Install a snap bushing found in hard- ware kit into one of the holes found rear of valve cover shield. The other hole is for a strain relief clamp (not supplied) to secure incoming electrical supply.

2.Follow steps 2 through 6 in Installing Blower Assembly, page 11.

3.A licensed electrician must follow the wiring diagram to connect incoming electrical supply to fan kit wiring har- ness (see Figure 19).

4.Plug power cord to the outlet receptacle (not provided) as shown in Figure 20. Wind the extra cable in power cord and and tie it up with the plastic wire strap

Fan Switch

(Auto/Off/On)

1 Auto

(see Figure 20). Set the cable bundle between the burner bracket and outer casing, away from the burner.

5.Test to make sure the blower is work- ing properly.

6.Reinstall upper louver assembly (see Fig- ure 15, page 11) and close lower louver.

Use extension cord if needed. The cord must have a three-prong, grounding plug and a three-hole receptacle. Make sure cord is in good shape. It must be heavy enough to carry the current needed. An undersized cord will cause a drop in line voltage. This will result in loss of power and overheating. Use a No. 16 AWG cord for lengths less than 50 feet.

switch is in the ON position, the fan will

run until turned to OFF. Reinstall upper

louver assembly (see Figure 15, page 11)

and branch support. Close lower louver

door.

Valve Cover

Shield

	Off	2
		3		Blue	Thermostat
			On			Switch
			On			(N.O.)
110/115			Red				Blue
V.A.C.			Red				Blower
	Black							Motor
	Black					Red
	White					White
	Green					Green

Figure 19 - Wiring Diagram For Blower Accessory Built-In Installation

Blower Bracket Assembly

Switch Screw

Plate

Figure 17 - Installing Switch Plate to Valve Cover Shield

Fan Switch

(Auto/Off/On)

1Auto

Screw

Wire Harness

		Off	2
			3
			On
110/115			Red
	V.A.C.
		Black
		Black
		White
		Green

Blue Thermostat

Switch

(N.O.)

Blue

Blower

Motor

Red

White

Green

Switch	Power	Outlet
	Cord	Receptacle
		(Not Supplied)

Figure 18 - Wiring Diagram For Blower Accessory Standard Installation

For Built-In Installation

WARNING: A licensed electri- cian must connect the wiring har- ness to electrical supply following all local codes. Electrician must provide a clamp on the box cover to securethewiring.Wiringshouldbe routed through the bushing in the hole on the outer casing of heater.

Blue Red

Switch

Plastic

Wire Wire

Harness Strap

Clamp Connector (not included)

Figure 20 - Installing Blower Bracket Assembly

For more information, visit www.desatech.com

107034