Vanguard Heating VMH26PRA installation manual Accessories

Page 28

® VMH26PRA

COMPACT CLASSIC HEARTH FIREPLACE

ACCESSORIES

Purchase these fireplace accessories from your local dealer. If they cannot supply these accessories call DESA International’s Sales Department at 1-800-458-2472 for referral information. You can also write to the ad- dress listed on the back page of this manual.

EQUIPMENT SHUTOFF VALVE - GA5010

Equipment shutoff valve with 1/8" NPT tap.

THERMOSTATICALLY - CONTROLLED BLOWER KIT GA3400T

Provides better heat distribution. Makes fire- place more efficient. Automatically turns off and on as needed.

CABINET MANTEL WITH BUILT-IN HEARTH BASE AND TRADITIONAL SQUARE LEG STYLING

Unfinished - GM923U

Finished - GM922F

For use with fireplace. A hardwood mantel and hearth base offers compact styling and completes the fireplace look. Available in a stained or an unfinished (ready to stain or paint) Oak Veneer over hardwood. Com- plete assembly instructions included. Three- sided brass trim kit included.

BRASS TRIM KIT - GA6095

Optional four-sided brass trim kit for recessed built-in installations (when unit is raised off of the floor). Provides a finished appearance by covering rough edges of wall opening.

BRASS TRIM KIT - GA6094

(Not Shown)

Optional three-sided brass trim kit for cus- tom and recessed installations (when unit is on the floor). Provides a finished appear- ance by covering rough edges of wall open- ing. Included with all mantels.

CABINET MANTEL WITH BUILT-IN HEARTH BASE AND ROUNDED LEG STYLING

Unfinished - GM921U Walnut Finished - GM920F Cherry Finished - GM924F (Appearance May Differ by Model)

For use with fireplace. A hardwood mantel and hearth base offers compact styling and completes the fireplace look. Available in a walnut finished, cherry finished, or an un- finished hardwood, ready to stain or paint. Complete assembly instructions included. Three-sided brass trim kit included.

CORNER MANTEL WITH BUILT-IN HEARTH BASE

Unfinished - GM721U

Finished - GM720F

For use with fireplace. Space-saving mantel and hearth base corner design features clean, classic lines. Available in a walnut finish or an unfinished hardwood, ready to stain or paint. Complete assembly instructions in- cluded. Three-sided brass trim kit included.

For more information, visit www.desatech.com

28

107034

Image 28
Contents VENT-FREE PROPANE/LP GAS What to do if YOU Smell GASSafety Information Compact Classic Hearth FireplaceProduct Features Remote Control AccessoriesLocal Codes UnpackingAssembly Installing LogAssembling Fireplace Assembling HoodAIR for Combustion and Ventilation Providing Adequate VentilationUnusually Tight Construction Confined and Unconfined SpaceDetermining FRESH-AIR Flow for Fireplace Location AIR for Combustion VentilationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Installation Installation ItemsCheck GAS Type Locating FireplaceBUILT-IN Fireplace Installation Rough Opening for Installing in WallMantel Clearances for Built-In Installation Optional Mantel InstallationAssembling Brass Trim Brass trim shipped with mantel Installing Blower Assembly Installing Blower Accessory GA3400TRemoving Upper Louver Assembly For Built-In Installation Extension CordAttaching Wood Base to Solid Floor Connecting to GAS SupplyFor attaching base to solid floors concrete or masonry Connecting Fireplace to GAS Supply Installation Items NeededPressure Testing Gas Supply Piping System Pressure Testing Fireplace Gas ConnectionsChecking GAS Connections Optional Wireless HAND- Held Remote Control Accessories Installing ReceiverInstalling 9-Volt Battery in Hand- Held Remote Control Unit Wire harness provided in the fireplace hardware packOptional Wall Switch GWMS2 Operating Fireplace For Your Safety Read Before LightingLighting Instructions To Turn OFF GAS To Appliance Manual Lighting ProcedureOptional Remote Operation GWMS2 Wall Mounted Switch Optional Inspecting BurnersGWMT1 Wall Mounted Thermostat Optional Operating BlowerCleaning and Maintenance Cleaning Burner Injector Holder and Pilot AIR Inlet HoleInspecting Burner Burner Flame PatternTroubleshooting Observed Problem Possible CauseLation requirements Pane/LP gas companyGas odor even when control knob is in OFF Vice personCarpet, etc. See Important state Is running Ment above PositionSpecifications Replacement PartsService Hints Technical ServiceIllustrated Parts Breakdown VMH26PRA4Parts List VMH26PRAAccessories Cleaning KIT CCK Wall Mounted Switch KIT GWMS2Wall Mounted Thermostat KIT GWMT1 Warranty Information International