Desa CF26NR installation manual For Built-In Installation, Place log set back on the unit

INSTALLATION

Installing Blower Assembly - GA3450T (Cont.)

11

INSTALLATION

Continued

10.Install the switch plate on the blower control shield with 2 - #10 screws provided (see Figure 16). Route power cord out of the cabinet by inserting it through the bushing on the outer casing (see Figure 15). Plug fan kit into 120-Volt grounded power supply and test operation. Note: When switch is in the AUTO position, the fan will start after the heater has run for a few moments. The fan will continue to run for several mo- ments after the heater has been turned off. When switch is in the ON position, the fan will run until turned to OFF. Reinstall hood assembly and close lower louver door.

For Built-In Installation

WARNING: A licensed electrician must connect the wiring harness to electrical supply following all local codes. Electrician must provide a clamp on the box cover to secure the wiring. Wiring should be routed through the bushing in the hole on the outer casing of heater.

11. Place log set back on the unit.

Blower Bracket

Assembly

Screw

Switch

Wiring

Routing Hole

Heat

Deflector

WARNING: ELECTRICAL GROUNDING INSTRUC- TIONS This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle.

1.Install a snap bushing found in hardware kit into one of the holes found on rear of blower control shield. The other hole is for a strain relief clamp (not supplied) to secure incoming elec- trical supply.

2.Follow steps 2 through 6 in Installing Blower Assembly, page 10. Also remove black wire from middle/OFF switch terminal.

3.Remove black plastic strain relief and power cord from switch plate (see Figure 17). The power cord supplied will not be used in built-in installations. Pop in the plastic snap bushing found in hardware kit into the hole left by supply cord/strain relief.

Blower Bracket

Assembly

Screw

Figure 15 - Installing Blower Bracket Assembly

Blower

Control Shield

Switch Plate

Screw

Figure 16 - Installing Switch Plate to Blower Control Shield

Figure 17 - Installing Blower Bracket Assembly