Desa CF26NR Installing Logs, Optional Wireless HAND-HELD Remote Control Accessories

INSTALLATION

Installing Logs Optional Wireless Hand-Held Remote Control Accessories

15

INSTALLATION

Continued

INSTALLING LOGS

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs accord- ing to the log installation instructions in this manual. Flames contacting logs will create soot.

It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

Place one-piece log set on grate to fit as illustrated in Figure 24. Make sure back section of log set is seated into “U”-shaped cutout in center of chassis (see Figure 24). IMPORTANT: Make sure log does not cover any burner ports (see Figure 25).

One Piece Log Set

Burner

Figure 25 - Installing One-Piece Log set (Top View)

OPTIONAL WIRELESS HAND-HELD REMOTE CONTROL ACCESSORIES

(CGHRC & CGHRCT Series)

Installing Receiver

1.Disconnect switch wires from the control valve.

2.Remove screws and nuts.

3.Remove switch plate (see Figure 26). Discard after removing.

4.Install remote receiver unit onto gas log heater base using clips

(2) and insulating washers provided.

5.Push clips firmly into place (see Figure 27).

6.Connect wires as shown in Figure 28.

Front

Screw

Back

Nut

Nut Wires

Figure 26 - Switch Plate and Wiring Harness (Switch Plate and Orientation May Vary Depending On Model)

Front

Mounting

Clips

Back

Remote

Receiver

Insulating Washers

Figure 27 - Installing Remote Receiver

Valve

White Wire

From Receiver

Red Wire From

Receiver

Figure 28 - Connecting Wires