Desa CF26NR installation manual Operating Fireplace, Installing Wireless Remote Control Accessory

Page 16

16

INSTALLATION

Installing Wireless Remote Control Accessory

OPERATING FIREPLACE

For Your Safety Read Before Lighting

INSTALLATION

Continued

INSTALLING WIRELESS REMOTE CONTROL ACCESSORY

Two 9-volt alkaline batteries (not included) are required to operate this heater with the wireless hand held remote control set. One battery must be installed in the receiver and one in the hand-held remote control unit. Note: Only use alkaline batteries.

Installing 9-Volt Battery in Receiver

1.Locate back of receiver under front burner of heater.

2.Locate the battery clip mounted on the back of the receiver.

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Receiver

Terminal

9-Volt

Terminal

Wires

Battery

 

Remote

Control

Unit

Battery

Cover

Figure 31 - Installing Battery in Hand-Held Remote Control Unit (CGHRCTA Series)

OPERATING FIREPLACE

FOR YOUR SAFETY READ

BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop-

9-Volt

Wires

erty damage, personal injury or loss of life.

Battery Battery

Clip

Figure 29 - Installing Receiver on the Back of the Base

Installing 9-Volt Battery (Not Included) in Hand- Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to the battery. Place battery into the bat- tery housing.

3.Replace battery cover onto remote control unit.

Battery

Remote

Terminal Cover

Control Unit

Wires

 

9-Volt

 

Battery

 

 

Battery

 

Housing

Figure 30 - Installing Battery in Hand-Held Remote Control Unit (CGHRC Series)

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire de- partment.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

For..com

105443-01E

Image 16 Contents
Unvented VENT-FREE Natural GAS BAY Front Fireplace OWNER’S Operation and Installation ManualWhat to do if YOU Smell GAS Table of Contents Safety InformationProduct Identification Local CodesProduct Features Remote Control AccessoriesUnpacking AIR for Combustion and VentilationConfined and Unconfined Space Determining FRESH-AIR Flow for Fireplace LocationDetermining if You Have a Confined or Unconfined Space Installation Ventilation AIRCheck GAS Type Ventilation Air From Inside BuildingBUILT-IN Fireplace Installation Locating FireplaceRough Opening for Installing in Wall Mantel Clearances for BUILT-IN Installation Optional Mantel InstallationAssembling Brass Trim Removing Brick Liner RetainerInstalling Blower Assembly GA3450T Removing Hood ScrewsFor Built-In Installation Place log set back on the unitConnecting to GAS Supply Installation ItemsConnecting Fireplace to GAS Supply Installation Items NeededPressure Testing Fireplace Gas Connections Pressure Testing Gas Supply Piping SystemChecking GAS Connections Optional Wireless HAND-HELD Remote Control Accessories Installing LogsCghrc & Cghrct Series Installing Receiver Installing Wireless Remote Control Accessory For Your Safety Read Before LightingInstalling 9-Volt Battery in Receiver Operating FireplaceManual Lighting Procedure Lighting InstructionsTo Turn OFF GAS To Appliance Shutting Off HeaterOptional Remote Operation Thermostat Control OperationCghrc Series Operation Cghrcta Series OperationCleaning Maintenance Inspecting BurnersSpecifications Wiring DiagramCabinet Air PassagewaysTroubleshooting Observed Problem Possible Cause RemedyRefer to Air for Combustion and Venti Top Illustrated Parts Breakdown CF26NRParts List KEY Part Number Description QTY20-1 11-1 11-2 20-2 20-3 KEY CF26NR Description QTY Replacement Parts Technical ServiceService Hints Parts CentralsOwners Registration Form Tape Brass Accent Trim GA6095 Receiver and HAND-HELD Remote Control KIT Cghrc SeriesInformation Video Warranty Information
Related manuals
Manual 32 pages 21.74 Kb