Desa EFS10TPA Optional Wireless HAND-HELD Remote Control Accessories, Installing Receiver

INSTALLATION

Continued

OPTIONAL WIRELESS HAND-HELD

REMOTE CONTROL ACCESSORIES

Remote-Ready Models Only

(GHRCB Series & GHRCTB Series)

Installing Receiver

White Wire to TH Terminal on Control

Valve

Remote

Receiver

Red Wire to

TPTH

Terminal on

Control Valve

1.Disconnect jumper wire from control valve (see Figure 27).

2.Locate battery clip mounted on back of re- ceiver (see Figure 28).

3.Slide 9-volt battery (not included) through clip.

4.Attach terminal wires to battery (see Figure 29).

5.Connect wires from remote receiver to con- trol valve as shown in Figure 29.

6.Install remote receiver unit onto remote/ blower bracket using screws provided (see Figure 29).

Control

Valve

Jumper

Wire

Figure 27 - Disconnecting Wires From

Control Valve

Receiver

Figure 29 - Installing Remote Receiver

Installing 9-Volt Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote con- trol unit.

2.Attach terminal wires to the battery (not in- cluded). Place battery into the battery housing.

3. Replace battery cover onto remote control unit.

Battery Cover

Terminal

Wires

Remote

Control

Unit

9-Volt Battery	Battery
	Housing

Figure 30 - Installing Battery in Hand-

Held Remote Control Unit (GHRCB and

CGHRCB Series)

9-Volt

BatteryTerminal

Wires Battery Clip

Figure 28 - Attaching Battery to Receiver

9-Volt Battery

Remote

Terminal Control Unit

Wires

	Battery
Battery	Cover
Housing

Figure 31 - Installing Battery in Hand-

Held Remote Control Unit (GHRCTB and

CGHRCTB Series)

112462-01B www.desatech.com 21