Desa VI33PRA, VI33NRA installation manual Unvented VENT-FREE GAS Fireplace Insert

Page 1

UNVENTED (VENT-FREE) GAS

FIREPLACE INSERT

OWNER’S OPERATION AND INSTALLATION

®MANUAL

For..com

VI33NRA

 

VI33PRA

 

REMOTE READY

Patent Pending

GAS FIREPLACE

Shown with GS38

INSERT

Surround Kit and

 

G8010 Brick Liner

 

Accessories

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result caus- ing property damage, personal injury, or loss of life.

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s in- structions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a quali- fied installer, service agency, or the gas supplier.

WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Refer to this manual for correct installation and operational procedures. For assis- tance or additional information consult a qualified installer, ser- vice agency, or the gas supplier.

WARNING: This is an unvented gas-fired heater. It uses air (oxy- gen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Refer to Air for Combustion and Ventilation sec- tion on page 4 of this manual.

This appliance may be installed in an aftermarket,* permanently located, manufactured (mobile) home, where not prohibited by local codes.

This appliance is only for use with type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

* Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer

Save thisfor.

Image 1
Contents Unvented VENT-FREE GAS Fireplace Insert OWNER’S Operation and Installation ManualWhat to do if YOU Smell GAS Safety Information Table of ContentsProduct Identification Log Base AssemblyProduct Features Remote Control AccessoriesLocal Codes UnpackingDetermining FRESH-AIR Flow for Heater Location Providing Adequate VentilationUnusually Tight Construction Confined and Unconfined SpaceVentilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Installing Surround KIT GS38 or GS43 InstallationBlower Accessory Check GAS TypeAttaching Left Installing HoodFireplace Insert Installation Into Masonry Fireplace Installation ClearancesInstalling GAS Piping to Fireplace Location Fireplace Insert Installation Into FRAMED-IN EnclosureMantel Clearances for Insert Installation Installation Items NeededPropane/LP Connecting Fireplace Insert to GAS SupplyChecking GAS Connections Pressure Testing Gas Supply Piping SystemPressure Testing Fireplace Insert Gas Connections Installing LogsGhrcta Installing Remote Receiver UnitFor Your Safety Read Before Lighting Installing 9-VOLT BatteriesInstalling 9-Volt Battery Not Included in Receiver Operating Fireplace InsertTo Turn OFF GAS to Appliance Manual Lighting ProcedureShutting Off Heater Shutting Off Burners Only pilot stays litThermostat Control Operation Optional Remote OperationGhrc Series Operation Ghrcta Series OperationInspecting Burners Cleaning Burner Injector Holder and Pilot AIR Inlet Hole Cleaning MaintenanceLogs Observed Problem Possible Cause TroubleshootingMaintenance, Observed Problem Possible Cause Remedy Replacement Parts Wiring DiagramsService Hints SpecificationsRemote Ready Model VI33NRA Illustrated Parts BreakdownKEY Part Number Description QTY Parts ListRemote Ready Model VI33PRA 103877-01 Lighting Instruction Plate 100563-01 Fireplace Insert VI33NRA VI33PRA 101784-01 Magnet Catch 102307-01 Strike Plate WALL-MOUNT Thermostat Switch Receiver and HAND-HELD Remote Control KIT Ghrc SeriesWALL-MOUNT ON/OFF Switch GWMS2 Cleaning KIT CCK110150-01A Warranty Information