Desa VI33PRA, VI33NRA installation manual Product Identification, Log Base Assembly

Page 3

SAFETY INFORMATION PRODUCT IDENTIFICATION

3

SAFETY INFORMATION

Continued

Keep the appliance area clear and free from combus- tible materials, gasoline, and other flammable vapors and liquids.

1.This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

2.Do not place propane/LP supply tank(s) inside any structure. Lo- cate propane/LP supply tank(s) outdoors (propane/LP units only).

3.If you smell gas

shut off gas supply

do not try to light any appliance

do not touch any electrical switch; do not use any phone in your building

immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions

if you cannot reach your gas supplier, call the fire department

4.This fireplace insert shall not be installed in a bedroom or bathroom.

5.Do not use this fireplace insert as a wood-burning fireplace. Use only the logs provided with the fireplace insert.

6.Do not add extra logs or ornaments such as pine cones, ver- miculite, or rock wool. Using these added items can cause soot- ing. Do not add lava rock around base. Rock and debris could fall into the control area of fireplace insert.

7.This fireplace insert is designed to be smokeless. If logs ever ap- pear to smoke, turn off fireplace insert and call a qualified service person. Note: During initial operation, slight smoking could oc- cur due to log curing and burning of manufacturing residues.

8.To prevent the creation of soot, follow the instructions in Clean- ing and Maintenance, page 19.

9.Before using furniture polish, wax, carpet cleaner, or similar products, turn heater off. If heated, the vapors from these prod- ucts may create a white powder residue within burner box or on adjacent walls or furniture.

10.This fireplace insert needs fresh air ventilation to run properly. This fireplace insert has an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS shuts down the fireplace if not enough fresh air is available. See Air for Combustion and Ventilation, pages 4 through 6. If fireplace insert keeps shut- ting off, see Troubleshooting, pages 20 through 22.

11.Do not run fireplace insert

where flammable liquids or vapors are used or stored

under dusty conditions

12.Do not use this fireplace insert to cook food or burn paper or other objects.

13.Do not use fireplace insert if any part has been exposed to or under water. Immediately call a qualified service technician to inspect the fireplace insert and to replace any part of the con- trol system and any gas control which has been under water.

14.Do not operate fireplace insert if any log is broken. Do not operate fireplace insert if a log is chipped (dime-sized or larger).

15.Turn fireplace insert off and let cool before servicing. Only a quali- fied service person should service and repair fireplace insert.

16.Operating fireplace insert above elevations of 4,500 feet could cause pilot outage.

17.To prevent performance problems, do not use propane/LP fuel tanks of less than 100 lbs. capacity (propane/LP units only).

18.Provide adequate clearances around air openings.

PRODUCT IDENTIFICATION

One Piece

Log Set

Optional

Remote

Control

Control

Knobs Piezo

Ignitor Remote Selector

Switch (Optional)

Figure 1 - Log Base Assembly

Top Louver

Top Outer

Assembly

Casing

 

Firebox

 

Hood

 

Firebox

 

Support

 

Gas

Line

Access

Screen

AssemblyBlower

Assembly

Bottom Louver

Assembly

Figure 2 - Fireplace Insert

For morevisit www..com

110150-01A

Image 3
Contents OWNER’S Operation and Installation Manual Unvented VENT-FREE GAS Fireplace InsertWhat to do if YOU Smell GAS Safety Information Table of ContentsProduct Identification Log Base AssemblyUnpacking Remote Control AccessoriesProduct Features Local CodesConfined and Unconfined Space Providing Adequate VentilationDetermining FRESH-AIR Flow for Heater Location Unusually Tight ConstructionVentilation AIR Ventilation Air From Inside BuildingVentilation Air From Outdoors Check GAS Type InstallationInstalling Surround KIT GS38 or GS43 Blower AccessoryAttaching Left Installing HoodFireplace Insert Installation Into Masonry Fireplace Installation ClearancesInstallation Items Needed Fireplace Insert Installation Into FRAMED-IN EnclosureInstalling GAS Piping to Fireplace Location Mantel Clearances for Insert InstallationPropane/LP Connecting Fireplace Insert to GAS SupplyChecking GAS Connections Pressure Testing Gas Supply Piping SystemPressure Testing Fireplace Insert Gas Connections Installing LogsGhrcta Installing Remote Receiver UnitOperating Fireplace Insert Installing 9-VOLT BatteriesFor Your Safety Read Before Lighting Installing 9-Volt Battery Not Included in ReceiverShutting Off Burners Only pilot stays lit Manual Lighting ProcedureTo Turn OFF GAS to Appliance Shutting Off HeaterGhrcta Series Operation Optional Remote OperationThermostat Control Operation Ghrc Series OperationInspecting Burners Cleaning Maintenance Cleaning Burner Injector Holder and Pilot AIR Inlet HoleLogs Observed Problem Possible Cause TroubleshootingMaintenance, Observed Problem Possible Cause Remedy Specifications Wiring DiagramsReplacement Parts Service HintsRemote Ready Model VI33NRA Illustrated Parts BreakdownKEY Part Number Description QTY Parts ListRemote Ready Model VI33PRA 103877-01 Lighting Instruction Plate 100563-01 Fireplace Insert VI33NRA VI33PRA 101784-01 Magnet Catch 102307-01 Strike Plate Cleaning KIT CCK Receiver and HAND-HELD Remote Control KIT Ghrc SeriesWALL-MOUNT Thermostat Switch WALL-MOUNT ON/OFF Switch GWMS2110150-01A Warranty Information