16
OPERATING FIREPLACE INSERT
Lighting Instructions (Cont.)
To Turn Off Gas To Appliance
Manual Lighting Procedure
OPERATING FIREPLACE INSERT
Continued
4.Press in and turn control knob clockwise 
to the OFF position.
5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low “B” in the safety information in column 2, page 15. If you don’t smell gas, go to the next step.
6.Press in and turn control knob counterclockwise 
to the PILOT position. Press in control knob for five (5) seconds (see Figure 32).
Note: You may be running this heater for the first time after hooking up to gas supply. If so, the control knob may need to be pressed in for 30 seconds or more. This will al- low air to bleed from the gas system.
7.With control knob pressed in, press and release ignitor but- ton. This will light pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor button until pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure.
8.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs. Note: If pilot goes out, repeat steps 4 through 8.
9.Slightly push in and turn control knob counterclockwise 
to the ON position.
10.Wait one minute and switch selector switch to the ON posi- tion to light burners.
11.Set flame adjustment knob to any level between HI and LO.
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
Ignitor Button |
| ||
IH |
|
|
|
|
| O |
|
|
| F | AUTO |
N |
| F | |
O | TOL | P | OFF |
LO |
| ||
| I |
| |
|
|
| ON |
WARNING: Make sure the selector switch is in the OFF position when you are away from home for long periods of time. Heater will come on automatically with selector switch in the ON position.
Pilot | Ignitor | Pilot | Ignitor |
Burner | Electrode | Burner | Electrode |
Natural Gas
Propane/LP Gas
Figure 33 - Pilot
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater
1.Turn control knob clockwise 
to the OFF position.
2a. Set selector switch in the OFF position.
2b. If Using Optional
Shutting Off Burners Only (pilot stays lit)
You may shut off the burners and keep the pilot lit by doing one of the following:
•Turn control knob clockwise 
to the PILOT position.
•Use remote control manual OFF button.
•Set remote selector switch in the OFF position.
MANUAL LIGHTING PROCEDURE
1.Follow steps 1 through 6 under Lighting Instructions, page 15 and column 1.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, column 1.
Flame Adjustment | Control Knob | Selector Switch |
Knob |
| |
|
|
Figure 32 - Control Knob and Ignitor Button Location (Shown as
Supplied, No Control Options)
For
.
.com
