Desa VSGF28NTE, VSGF28PTE installation manual Gas leak. See Warning, Statement above

Page 24

TROUBLESHOOTING

Continued

WARNING: If you smell gas

Shut off gas supply.

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

IMPORTANT: Operating fireplace where impurities in air exist may create odors. Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new carpet or textiles, etc., create fumes. These fumes may mix with combustion air and create odors. These odors will disappear over time.

OBSERVED PROBLEM POSSIBLE CAUSE

REMEDY

Fireplace produces unwanted 1.

Fireplace burning vapors from

odors

paint, hair spray, glues, clean-

 

ers, chemicals, new carpet, etc.

 

(See IMPORTANT statement

 

above)

2.

Gas leak. See Warning

 

statement above

1.Open window and ventilate room. Stop using odor caus- ing products while fireplace is running

2.Locate and correct all leaks (see Checking Gas Connec- tions, page 15)

Fireplace shuts off in use (ODS

1. Not enough fresh air is avail-

1.

Open window and/or door for

operates)

 

able

 

ventilation

 

2.

Low line pressure

2.

Contact local propane/LP gas

 

 

 

 

company

 

3.

ODS/pilot is partially clogged

3.

Clean ODS/pilot (see Cleaning

 

 

 

 

and Maintenance, page 20)

 

 

 

 

Gas odor even when control

1. Gas leak. See Warning

1.

Locate and correct all leaks

knob is in OFF position

 

statement above

 

(see Checking Gas Connec-

 

 

 

 

tions, page 15)

 

2.

Control valve defective

2.

Replace control valve

 

 

 

 

 

Gas odor during combustion

1.

Foreign matter between con-

 

 

trol valve and burner

 

2.

Gas leak. See Warning

 

 

statement above

1.Take apart gas tubing and re- move foreign matter

2.Locate and correct all leaks (see Checking Gas Connec- tions, page 15)

Moisture/condensation noticed

1. Not enough combustion/ven-

1. Refer to Air for Combustion

on windows

tilation air

and Ventilation requirements

 

 

(page 6)

24

www.desatech.com

113135-01A

Image 24
Contents ¢QQQQQQ ¢ ¢ ¢ ¢ ¢ Table of Contents Safety Information Local Codes Product Features Product IdentificationUnpacking AIR for Combustion Ventilation Providing Adequate VentilationDetermining FRESH-AIR Flow for Heater Location Unusually Tight ConstructionVentilation AIR Ventilation Air From Inside BuildingInstallation Ventilation Air From OutdoorsInstalling Hood Check GAS TypeElectrical Hookup Installation Clearances Conventional Fireplace InstallationBUILT-IN Fireplace Installation Depth 16 11/16 17 3/4Installing GAS Piping to Fireplace Location Mantel Clearances for Built-In InstallationInstallation Items Needed Natural GasConnecting Fireplace to GAS Supply Propane/LPPressure Testing Gas Supply Piping System Pressure Testing Fireplace Gas ConnectionsChecking GAS Connections Installing Logs Installing Front Log #1For Your Safety Read Before Lighting Operating FireplaceLighting Instructions Manual Lighting Procedure To Turn OFF GAS To ApplianceThermostat Control Operation Blower OperationInspecting Burners Pilot Flame PatternFront Burner Flame Pattern Cleaning Maintenance Burner Injector Holder and Pilot AIR Inlet HoleLogs Troubleshooting Observed Problem Possible Cause RemedyPress in control knob fully Stalling Logs, Gas leak. See Warning Statement aboveSpecifications Wiring DiagramService Hints Replacement PartsIllustrated Parts Breakdown Parts List LOG Base AssemblyFireplace Models VSGF28NTE and VSGF28PTE KEY Part Number Description QTY Accessories Hardwood Hearth Base Corner Hearth BaseLaminate Trim for Hearth or Mantel Warranty Information Keep this WarrantyLimited Warranty VENT-FREE GAS Fireplace