Installation
Continued
4.Slide one end of adjusting plate/shim in slot on mitered edge of top trim (see Figure 6).
5.Slide other end of adjusting plate/shim in slot on mitered edge of side trim (see Figure 6).
6.While firmly holding edges of trim together, tighten both set screws on the adjusting plate with slotted screwdriver.
7.Repeat steps 1 through 6 for other side.
8.Tighten trim hanging screws (#10 x 6.25 shoul- der) into holes in cabinets. Place the assembled trim onto fireplace cabinet.Align hanging notches on trim with hanging screws on side of fireplace (see Figure 7). Push trim firmly into place, sliding hanging notches over hanging screws.
| Set Screws |
Side Trim Adjusting | Top |
Plate | Trim |
Mitered
Shim Edge
Mitered Slot
Slot Edge
Figure 6 - Assembling Perimeter Trim
Trim
Hanging
Screws
Hanging Notches on Trim
Assembled 
Trim
Figure 7 - Attaching Perimeter Trim to
Fireplace
INSTALLATION CLEARANCES
WARNING: Maintain the minimum clearances. If you can, provide greater clearances from floor, ceiling, and adjoining wall.
Carefully follow these instructions. This will ensure safe installation.
Minimum Clearances For Side Combustible
Material, Side Wall, and Ceiling
A. Clearances from the side of the fireplace cabinet to any combustible material and wall should follow diagram in Figure 8.
Example: The face of a mantel, bookshelf, etc. is made of combustible material and protrudes 3 1/2" from the wall. This combus- tible material must be 4" from the side of the fireplace opening (see Figure 8).
B. Clearances from the top of the fireplace opening to the ceiling should not be less than 42".
Example |
* |
*Minimum 16" from Side Wall
Figure 8 - Minimum Clearance for
Combustible to Wall
Conventional Fireplace
Installation
Conventional installation of this fireplace involves installing fireplace along with the corner, face, or cabinet mantel with hearth base accessories against a wall in your home. Follow the instructions in this section to install the fireplace in this manner.
1.Assemble cabinet mantel, hearth base, and trim accessories. Assembly instructions are included with each accessory.
2.When installing blower, install a properly grounded, 120 volt
3.Install gas piping to fireplace location. This in- stallation includes an approved flexible gas line (if allowed by local codes) after the equipment shutoff valve. The flexible gas line must be the last item installed on the gas piping. See Installing Gas Piping to Fireplace Location, page 13.
4.Place hearth base accessory against wall at instal- lation location. Cut an access hole in hearth top to run flexible gas line to fireplace (see Figure 9, page 11). Make sure to locate access hole so cabinet mantel will cover it when installed. Note: You can secure base to floor using wood screws. Countersink screw heads and putty over.
10 | www.desatech.com |