Desa VsGF28PTF Operating Fireplace, Thermostat Models, For Your Safety Read Before Lighting

Page 17

Installation

Continued

7.Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 26).

WARNING:You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.

Middle Left Log

Middle

Right Log

Pin on Front

Bottom

Left Log

Log

Figure 25 - Installing Top Logs

Notches

Screws for

Mounting

Screen

Figure 26 - Installing Fireplace Screen

Operating Fireplace

Thermostat Models

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

119303-01A

www.desatech.com

17

Image 17
Contents Thermostatically-controlled Models VSGF28NTF and VSGF28PTF What to do if YOU Smell GASSafety Information Table of ContentsSafety Information Local Codes Unpacking Product FeaturesProduct Identification Providing Adequate Ventilation Air For Combustion VentilationUnusually Tight Construction Confined and Unconfined SpaceDetermining if You Have a Confined or Unconfined Space Determining FRESH-AIR Flow for Heater LocationVentilation AIR InstallationVentilation Air From Inside Building Ventilation Air From OutdoorsCheck GAS Type Installing HoodConventional Fireplace Installation Installation ClearancesChecking Gas Connections, Built-In Firebox InstallationActual Framing Height Front WidthMantel Clearances for Built-In Installation Installing Gas Piping to Fireplace Location,Installation Items Needed Installing Gas Piping to Fireplace LocationAccessories, Connecting Fireplace to Gas SupplyNatural Gas Propane/LPTest Pressures Equal To or Less Than Psig 3.5 kPa Checking GAS ConnectionsPressure Testing Fireplace Gas Connections Installing LogsThermostat Models For Your Safety Read Before LightingOperating Fireplace To Turn OFF GAS To Appliance Lighting InstructionsThermostat Control Operation Shutting Off FireplaceInspecting Burners Manual Lighting ProcedureBlower Operation Pilot Flame PatternBurner Injector Holder Pilot Air Inlet Hole Cleaning MaintenanceSpecifications Wiring DiagramLogs Model VSGF28NTAIng and Maintenance, TroubleshootingObserved Problem Possible Cause Remedy Maintenance, Stalling Logs, See Checking Gas Connec Technical Service Replacement PartsService Hints AccessoriesDuplex Outlet KIT GA3555 Cleaning KIT GCKModels VSGF26NTF, VSGF26PTF Illustrated Parts BreakdownParts List Models VSGF28PTF and VSGF28NRF Parts List Limited Warranty VENT-FREE GAS Fireplace System Warranty InformationKeep this Warranty