Connecting the LP Tank

WARNING

ALL INSTRUCTIONS AND SAFEGUARDS ON THIS PAGE MUST BE

FOLLOWED TO PREVENT FIRE, DAMAGE AND / OR INJURY.

1.The knob on the LP tank must be closed. See that the knob is turned clockwise to full stop.

2.Check that the control knob on the smoker is turned off.

3.Remove the protective cap from the LP tank valve and coupling nut, if present.

4.Hold the regulator in one hand and insert the nipple into the valve outlet. Be sure the nipple is centered in the valve outlet. The coupling nut con- nects to the large outside threads on the valve outlet. Use care - do not cross thread the connection.

5.Hand tighten the coupling nut clockwise until it comes to a full stop. Firmly tighten by hand only. Do not use tools.

CAUTION: In the connection process, the HVR side of the connection will seal on the back check in the valve resulting in a slight resistance. The connection requires about one-half to three-quarters additional turn to com- plete the connection.

Any fuel supply cylinder used must be constructed and marked in accordance with speciﬁcations for propane cylinder of the U.S. Department of Transportation (DOT) CFR 49, or CAN/CSA B339. The ap- pliance is to be used only with 20 pound, vertical standing vapor withdrawal type tank.

(A) Do not store tanks under or near the smoker.

(B) Never ﬁll tanks more than 80% full.

If instructions A and B above are not followed exactly, a ﬁre causing death or serious injury may occur.

This smoker is designed to operate LP (Liqueﬁed Propane) gas only.

The 20 lb. LP cylinder used with this smoker must conform to the following requirements. Diameter 12” (30.5 cm)

Height 18” (45.7 cm)

With a maximum capacity of 20 pounds

The gas cylinder used must include a collar to protect the cylinder valve. The cylinder supply system must be arranged for vapor withdrawal.

The instructions stated on gas cylinder tanks have to be followed when ﬁlling or transporting tanks. Failure to do so could result in problems to overﬁlling, excessive venting release of gas and to regulator freezing.

Do not allow dirt or foreign material to get into or onto the tank connection when it is not attached to the fuel supply system. Use the protective cap provided.

Cylinder must be ﬁlled before initial use. All handling, transport, ﬁllng and storage of LP gas cylinders must be in accordance with NFPA 58 Storage and Handling of Liquid Petroleum Gasses, or CAN/CGA B149.2 Propane Installation Code. Cylinder must be suitably tied down during transportation. Do not place any other tiems on top of cylinders at any time. Cylinders are not to be exposed to excessive temperature or high heat.