Kenmore 125.15887800 owner manual Assembly, Step

ASSEMBLY

Choose a good, cleared assembly area and get a friend to help you put your smoker together. Lay cardboard down to protect smoker finish and assembly area.

CAUTION: Some parts may contain sharp edges. Wear protective gloves if necessary.

Note: With the help of a friend, turn the smoker cabinet upside down.

Step 1

For each leg, line up the holes and insert three 1/4-20 X 5/8” bolts, nuts are pre-welded to the cabinet. Securely tighten the bolts.

Note: With the help of a friend, turn the smoker body to its upright position. Try to minimize stress on legs.

Step 2

Install air vent tube by lining up the holes with the back panel holes on the inside of smoker cabinet. Insert two 10-24 X 1” bolts from the outside of the cabinet.

Step 3

From inside the cabinet, slide washers onto bolts and thread 10-24 flange nuts onto bolts. Securely tighten nuts.

Note: Line up the side handle with the corresponding holes on the side of the cabinet as shown.

Step 4

Attach side handles by using two

10-24 X 5/8” bolts through handle loops. Securely tighten. Repeat for other handle.

7